User manual AUDIOVOX 1287343

[. . . ] Image Sensor: 1/3" CCD Color Sensor NTSC: 510 X 492 picture elements 5. Weight: 2. 5 Oz 2 128-7223 3 of 12 Contents: 3 128-7223 4 of 12 Contents Description: 1. [. . . ] Weight: 2. 5 Oz 2 128-7223 3 of 12 Contents: 3 128-7223 4 of 12 Contents Description: 1. Check behind panel for wire routing access and confirm that the drill will not damage any existing components. Screw the lock nut with the threaded side toward the camera body in the showed direction, then put the camera neck through the mounting hole with the lens exposed and wire cable facing down. Place the flat washer 1 (# 6) and top cover (# 5); tighten the top cover (# 5) to the further location along the camera neck. Hold the top cover by hand and tighten the lock nut in towards the top cover (# 5) with the camera cable downwards. Locate suitable mounting location in the rear center of the vehicle and use the support bracket (# 2) as a template to mark and drill two 5/32" holes on the mounting location. Put the support bracket (# 2) onto the camera neck, then screw the lock nut along the camera neck to secure the bracket (# 2) to the camera body (# 1) in the showed direction. Screw the combine screws (or tapping screws) into the holes to attach the camera support bracket to the vehicle with the camera cable facing downwards. Place the protective cover (# 4) on the support bracket, then place the flat washer 1 (# 6) and top cover (# 5) on the camera neck. Tighten the top cover (# 5) to the further location along the camera neck towards the camera body. [. . . ] Screw the combine screws (or tapping screws) into the holes to attach the camera support bracket to the vehicle with the camera cable facing downwards. Place the protective cover (# 4) on the support bracket, then place the flat washer 1 (# 6) and top cover (# 5) on the camera neck. [. . . ]