User manual AUDIOVOX 1287180

[. . . ] Model APS-786T Owner's Manual 4 Button Remote Start Security System With Plug-In Shock Sensor & Starter Disable FEATURES: !Four Channel Code Learning Receiver (capable of accepting 4 transmitters) !7 Function LED - Arm / Disarm / Zone 1 / Zone 2 / Zone 3 / Valet / Arming !Programmable Door Lock Pulse Duration 1 Second / 3. 5 Seconds/1 Sec L/ Dbl. [. . . ] WHILE THE SYSTEM IS SOUNDING If during a triggered state, you wish to shut off the siren without disarming your security system, simply press and release any transmitter button other than the disarm button. This action will turn off the siren yet leave the vehicle fully armed and protected. This feature is particularly useful if you are aware of children playing near your vehicle that may accidently trigger your security system. INTRUSION WARNING SIGNAL This system will inform you if an intrusion attempt has occurred while you were away from the vehicle. Upon disarm, the siren will chirp 4 times and the parking lights will flash 3 times. Enter the vehicle and before turning on the ignition switch, observe the LED flash pattern. If the LED flashes one time. . . pause, one time. . . pause etc. , then an intrusion attempt was made by impact or a strong vibration that the shock sensor detected. If the LED flashes two times. . . pause, two times. . . pause etc. , then an intrusion attempt was made to open the hood, trunk, or by an accessory triggering device. If the LED flashes three times. . . pause, three times. . . pause etc. , then an intrusion attempt was made to the vehicle doors. NOTE: The LED intrusion warning indications are stored in the system's memory and will be erased when the ignition switch is turned on. VALET PUSH-BUTTON SWITCH: The valet switch allows you to temporarily bypass all alarm functions, eliminating the need to hand your transmitter to parking attendants or garage mechanics. When the system is in valet mode, all alarm functions are bypassed, however the remote panic feature and remote Page 4 128-7180 4 of 12 door locks will remain operational. Within 10 seconds, press and release the valet/override pushbutton switch, 3 times. Within 10 seconds, begin to enter your chosen 10ths digit by pressing and releasing the pushbutton switch from 1up to 9 times. Within 10 seconds of the last entered 10ths digit, turn the ignition switch off then on. Within 10 seconds, begin to enter your chosen units digit by pressing and releasing the pushbutton switch from 1 up to 9 times. If the new code was accepted, the unit will report back the newly entered code, by flashing the LED, first indicating the 10ths digit, pause and then the units digit. The unit will report the new code three times with a one second pause between each code, then the system will begin arming. If the LED flash pattern reports the previously stored code, the new code was not entered correctly. The unit will not recognize a 0 (Zero), or no digit entered in any place, units or tenths. Page 5 128-7180 5 of 12 NOTE: If 15 seconds of inactivity expire, or if the ignition switch is turned off for more then 5 seconds during any of the above steps, the unit will revert back to the last successfully stored code. Custom Code Programming Example: To Change the code from the factory pre-assigned code of 11 to "52" you would do the following: 1. Disarm the system by use of the transmitter, or by use of the emergency override sequence. [. . . ] This feature is especially useful in cold climates where the only means to keep the engine and engine fluids warm is to periodically start the engine. Be certain that the vehicle is outdoors before using this or any remote vehicle starting device. A running engine produces dangerous carbon monoxide fumes which can be harmful or fatal if prolonged exposure occurs. The parking lights will flash and the siren will chirp 4 times indicating the timed start mode is activated. [. . . ]