User manual AUDIOVOX 1286915A

[. . . ] Owners/Installation Guide For: CL-100 Telematics Upgrade Module Printed In Korea Form No. 128-6915A OWNERS MANUAL: The integration of this satellite controlled upgrade module will allow access to certain functions and features of your vehicle available through the use of a "Touch Tone Phone". [. . . ] 3) If you are faxing the form in, complete the name, address, phone number, and vehicle information blank areas on the form, sign & date then fax to 1-805-639-0346. After 24 hours, simply call 1-800-495-7677 to access any feature that has been checked on the activation form. This form indicates which features are available in your vehicle through your installed host module and telematic device. INSTALLATION: All Applications: Mounting The Module: The control module is designed to be mounted under the dashboard keeping in mind that the antenna is a PC Board mount antenna/receiver. The unit should be mounted as high in the dashboard as possible with only plastic above to allow the unit to properly receive the page signal from the satellite. The unit should be mounted within 36" of the host alarm module to insure the 4 pin cable reaches from the CL-100 to the alarm. In addition the unit SHOULD NOT be mounted near any other antenna/radiator that may interfere with reception or be mounted to metal braces, or any other control module which might adversely effect the signal. Connecting To The Host Module: NOTE: Be certain to record the unit's serial number found on the back of the module on the Activation Form. Be certain to check the boxes on the activation form next to the features available for your customer's vehicle. Be certain to enter your dealer ID number on the activation form in the area indicated. Be certain to fill in the subscriber number on the wallet card for your customer. After the host module has been installed and thoroughly tested, connect the 4 pin harness to the CL-100 and route the other end of the 4 pin harness to the host module. [. . . ] PRESS ((3) PLEASE ENTER YOUR DEALER ID, (XXXX), FOLLOWED BY THE # SIGN PLEASE ENTER YOUR PIN NUMBER, (XXXX), FOLLOWED BY THE # SIGN PLEASE ENTER THE SERIAL NUMBER TO BE TESTED, FOLLOWED BY THE # SIGN SELECTION OF VOICE PROMPTS FOR FEATURE TESTING ARE LISTED BELOW: 1. COMMANDS VPI 1 2 3 4 5 6 7 Commands Arm alarm Disarm alarm Door unlock Carjack/Theft Alarm reset Car Finder Aux 1 output Alarm Response 1 light flash - 1 siren chirps 2 light flashes - 2 siren chirps Door Unlock Full Trigger Reset (Armed mode) 1 light flash every 5 seconds for 3 minutes Aux1, 1second (-) pulse output 2/2 [. . . ]