User manual AUDIOVOX 1286682

DON'T FORGET : ALWAYS READ THE USER GUIDE BEFORE BUYING !!!

If this document matches the user guide, instructions manual or user manual, feature sets, schematics you are looking for, download it now. Diplodocs provides you a fast and easy access to the user manual AUDIOVOX 1286682. We hope that this AUDIOVOX 1286682 user guide will be useful to you.


AUDIOVOX 1286682 : Download the complete user guide (103 Ko)

Manual abstract: user guide AUDIOVOX 1286682

Detailed instructions for use are in the User's Guide.

[. . . ] Starter Inhibit Relay: Mount the starter inhibit relay near the ignition switch harness under the dashboard. You will have to locate and cut the low current starter wire later in the installation. Secure the relay in a convenient location with a cable tie or tape to existing harness. Be certain the relay's wires are accessible for making connections later during the wiring section of this installation. [. . . ] b) Within 8 seconds, press any button of the transmitter to be programmed. NOTE: If no transmitter button is activated, or the ignition switch is turned off, the unit will exit the program mode. Also, any time the program mode is entered and any transmitter is activated, all other transmitters will be erased. During the program sequence, you must have all transmitters present to be programmed that you wish to operate and activated one at a time during the program sequence. Each transmitter activated will cause the siren to chirp, once for the first, twice for the second and three times for the third. If a fourth is attempted to be programmed, the first will be erased and the fourth will move the other two forward in the program. Arming The System: With the system disarmed, press the arm/disarm button once. The siren will chirp once, and the LED will begin to flash and the engine starter will be disabled. During the armed mode, the unit can be triggered by shock/vibration, or a change in voltage such as the interior light turning on. Arming With The Two Stage Shock Sensor Bypassed: With the system disarmed, press the arm/disarm button once, the siren will chirp once. The siren will emit one short chirp indicating the system is set and will be fully armed in 5 seconds with the shock sensor bypassed for one arming cycle. Arming With The Voltage Sensor Bypassed: With the system disarmed, press the arm/disarm button once, the siren will chirp once. The siren will emit one long chirp indicating the system is set and will be fully armed in 5 seconds with the voltage sensor is bypassed. In The Triggered Mode: When the system is armed, if the voltage drops, or a strong vibration is presented to the protected vehicle, the unit will trigger. If a lesser vibration is presented to the vehicle, the shock sensor will emit a few warn away chirps. When triggered, the siren will sound for 30 seconds then reset and continue to protect your vehicle. During the triggered mode, the unit can be reset by disarming with the transmitter or by use of the override method described later in this manual. Disarming The System: With the system armed, press the arm/disarm button once, the siren will chirp two times indicating the system is disarmed. The LED will turn off and the starter disable relay will be enabled allowing the vehicle to start. If the siren chirped four times, this indicated that the system was triggered in your absence. Panic And Car Finder: The system offers the ability to activate the system from within the full operating range of the transmitter. This is useful in a panic situation where you may want to call attention to the vehicle to attract attention, or in a crowded parking lot to locate your vehicle. [. . . ] If the vehicle has no after fan, or delayed lighting system, then the unit can be set for 1 chirp, trigger capable 8 seconds after arming. After your selection is made, press the arm/disarm button one time to lock in the setting. NOTE: If there is no transmitter activity during this mode for 20 seconds, the unit will exit the program mode and return to the disarmed mode. Emergency System Override: If in the event the transmitter becomes inoperative while the system is armed, a method of overriding the alarm is required to allow you to start the vehicle. To override the system without the keychain transmitter: a) Open the vehicle door, the alarm system will sound. [. . . ]

DISCLAIMER TO DOWNLOAD THE USER GUIDE AUDIOVOX 1286682




Click on "Download the user Manual" at the end of this Contract if you accept its terms, the downloading of the manual AUDIOVOX 1286682 will begin.

 

Copyright © 2015 - manualRetreiver - All Rights Reserved.
Designated trademarks and brands are the property of their respective owners.