User manual AUDIOVOX 1286567

[. . . ] DO NOT remote start the vehicle if the car is garaged. 128-6567 1 of 4 YOUR "CODE HOPPING" TRANSMITTERS The transmitters included with your new remote start system use the most advanced and secure form of radio frequency transmission available on any current automotive remote system. Some of today's sophisticated auto thieves use a device known as a code grabber, which will receive and store the signal from your keychain transmitter, and retransmit at a later time to unlock your system. Your code hopping transmitters will change their signal every time the button is pressed, so when a thief grabs then re-transmits your signal, the system will not respond. If your transmitter button is pressed more than fifty times while it is out of range of the vehicle (children playing with your keys), the transmitter will not operate when you return to the vehicle, and will need to be re-aligned to the receiver. [. . . ] NOTE: The feature that has been added to channel 3 will always be activated using the same transmitter button that remotely starts the vehicle. There is no way to move the channel 3 function to a different transmitter button. ADDITIONAL REMOTE FUNCTION (CHANNEL 4) This system has an additional feature that can be connected to a number of different Page 2 128-6567 2 of 4 optional accessories. Some of the more common uses for this channel are: o Remote Trunk Release o Remote Window Closure o Remote Garage Door Interface To activate the optional accessory, press the option button on the keychain transmitter. Note: If your system utilizes the transmitter shown, the second option button may be configured to operate additional accessories. Please consult your installing retailer for more information concerning the options available. SAFETY (Red Handle) CONTROL SWITCH The control switch allows you to temporarily disable the remote starting function of your system. To disable the unit, move the red handle control switch to the off position. The control switch also allows you to select between 2 hour start up and 4 hour start up when using the automatic start up timer mode. Within 10 seconds, move the control switch off, on, off, on (2 switch cycles) to select a 2 hour start timer. After 10 seconds expire, the parking lights will flash 2 times confirming that the two hour start cycle is set. Or, within 10 seconds move the control switch off, on, off, on, off, on, off, on (4 switch cycles) to select a 4 hour start timer. The parking lights will flash 4 times confirming that the 4 hour start timer is set. REMOTE STARTING THE VEHICLE The system WILL NOT start the vehicle if any one of the following conditions exists: 1. Be certain that the vehicle is outdoors before using this or any remote vehicle starting device. A running engine produces dangerous carbon monoxide fumes which can be harmful or fatal if prolonged exposure occurs. To Remote Start The Vehicle: Press and release the trunk/key button of your keychain transmitter two times within 2 seconds. The vehicle will start and remain running for the pre-programmed 5, 10, 15 or 20 minutes. As a visual indication, the parking lights will flash or turn on dependent on the programming set up by your installation center. When you arrive at your vehicle, unlock it with the key or by pressing and releasing the trunk/key button of your keychain transmitter. [. . . ] The parking lights will flash and the siren will chirp 4 times indicating the timed start mode is activated. CANCELING THE AUTOMATIC START UP TIMER To cancel the automatic start up timer do one of the following; 1. Start the vehicle manually with the use of the ignition key and depress the brake pedal. Shut off the vehicle using the keychain transmitter by pressing and releasing the trunk/key transmitter button 2 times. FUNCTION SETTING CHART To be completed by installer: Door Lock Timer o 1 Sec. [. . . ]