User manual AUDIOVOX 1286461

[. . . ] Again, closing the hood, trunk, or doors will correct the problem and you do not need to disarm the system to make the correction. Turn off the engine, exit the vehicle, close and lock all doors, hood, and trunk. The dash mounted LED will begin to flash rapidly, indicating that the system is automatically (passive) arming. As an added convenience, the automatic passive arming will not begin until all doors and trunk lid are closed, allowing passengers to exit the vehicle at their convenience. [. . . ] The siren will "chirp" 2 times and the vehicle's parking lamps will flash two times. ACTIVE: The dash mounted LED will turn off, and remain off until the system is re-armed. PASSIVE: Never attempt to disarm the system from a distance that prevents you from opening a door within 30 seconds. Since the system is programmed for passive arming, it will begin to re-arm until a door is opened. INTRUSION WARNING SIGNALS: The system will inform you if an intrusion attempt has occurred while you were away from the vehicle. If an intrusion attempt has occurred, the siren will "chirp" 4 times when disarming the system. The vehicle's parking lights will also flash 3 times to indicate an intrusion has occurred. Enter the vehicle and observe the dash mounted LED for further information. etc. , then an intrusion attempt was made to a light activated entry point, or the shock sensor was activated. If the LED is flashing two times. . . pause. . . two times. . . etc. , then an intrusion attempt was made to the hood, trunk, or an optional sensor that has been connected to zone 2. If the LED is flashing three times. . . pause. . . three times. . . etc. , then an intrusion attempt was made through one of the vehicle's doors. These intrusion warning indicators are stored in the system's memory, and will only be erased from memory when the ignition key is turned on. VALET / SYSTEM OVERRIDE SWITCH: The "Valet" switch allows you to temporarily bypass all alarm functions, eliminating the need to hand your transmitter to parking attendants or garage mechanics. When the system is in valet mode, all alarm functions are bypassed, however, the remote panic feature and remote door locks (optional) will remain operational. Enter the vehicle and turn the ignition key to the "on" position. Press and hold the valet push-button switch for 5 seconds until the dash mounted LED turns on solid. To return to normal operation, with the ignition switch on, press and release the valet push-button switch one time. The LED will turn off indicating the unit has been returned to the normal mode of operation. In the event you lose your keychain transmitter, or if the transmitter fails to disarm the system, the valet switch can be used as a system override switch. The Page 3 128-6461 3 of 5 alarm will stop sounding, and the vehicle can now be started. NOTE: Always remember to exit Valet Mode to ensure that the vehicle remains protected at all times. ELIMINATING THE ARM / DISARM CHIRPS: The normal arming and disarming confirmation "chirps" can easily be turned on and off using the valet push-button switch. [. . . ] NOTE: This feature will not operate when the vehicle's ignition key is turned "ON". Page 4 128-6461 4 of 5 APS-15CH SYSTEM FUNCTIONS AT A GLANCE DASH LED INDICATORS RAPID FLASHING . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . PASSIVE ARMING SLOW FLASHING . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . ARMED OFF . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . DISARMED ON - SOLID . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . [. . . ]