User manual AUDIOVOX 1286286

[. . . ] Unauthorized antennas, modifications, or attachments could damage the transmitter and may violate FCC regulations. Normal Position: Hold the transmitter approximately 1" from your face and speak in a normal voice, with the antenna pointed up and away. -3- FUNCTION AND LOCATION OF THE CONTROLS 12 11 6 1 7 8 2 14 CHANNEL FRS CALL F 9 10 3 4 5 -4- 1. Monitor Button (M): Press and hold to bypass the squelch and listen to channel activity. Up Button ( ): Press this button to increase the volume or channel setting. [. . . ] Volume Level Audio reception volume is controlled by the Up (F) and the Down (G) button. Momentarily pressing either button will increase or decrease the volume level, with each step accompanied by a beep tone. The display will indicate o1 (lowest setting) to o 8 (highest setting). -9- Call Button (8) When the call button is pressed, the FR-141 will transmit a 3-second ringing sound to other transceiver's tuned to the same channel. This feature can be used to signal other parties that voice communication is desired. The call icon ) appears on the LED display while the call tone sounds. ( Low Battery Alert When the battery level becomes low, the battery icon ( recharge or replace the batteries with new ones. In this case, Monitor Button (M) You can monitor channel activity by pressing the Monitor (M) button (2). If pressed for more than 2 seconds, you can continuously monitor channel activity. Function Select (F) Button Pressing the Function button will allow selection of frequency channels, as well as selection of the various unit functions. Each press permits selection of the desired channel (1­14), Scan, Dual Watch, VOX, Roger Beep and Beep Tone functions. This button also activates the Key lock feature ( ) when pressed and held for more than 2 seconds. Channel Selection Press function button once until large two-digit channel display flashes. Press Up ( ) or Down ( ) buttons to select desired channel (1­14). Channel Scanning Press the Function (F) button two times until the SC icon flashes. Press the Up ( ) button to enable the Scan function in the upward channel direction. Press the Down ( ) button to enable the Scan function in the downward channel direction. Once selected, the Scan icon (SC) will appear steadily on the display. While in Scan mode, the unit will pause on any active channel for 5 seconds, -10- FUNCTIONS and then channel scanning will resume. The unit will scan channels 1­14 for activity and scanning will continue until the monitor, or Function button is pressed. If scanning is interrupted by using the PTT button, scanning will resume approximately 6 seconds after the respective button is released. Dual Watch Mode This feature allows monitoring of two channels simultaneously. Press the Function (F) button three times until the Dual Watch icon (DW) flashes on the display. [. . . ] dated bill of sale), specification of defect(s), transportation prepaid, to the warranty center at the address shown below. The Company disclaims liability for communications range of this product. This Warranty does not apply to any product or part thereof which, in the opinion of the Company, has suffered or been damaged through alteration, improper installation, mishandling, misuse, neglect, accident, or by removal or defacement of the factory serial number/bar code label(s). THE EXTENT OF THE COMPANY'S LIABILITY UNDER THIS WARRANTY IS LIMITED TO THE REPAIR OR REPLACEMENT PROVIDED ABOVE AND, IN NO EVENT, SHALL THE COMPANY'S LIABILITY EXCEED THE PURCHASE PRICE PAID BY PURCHASER FOR THE PRODUCT. [. . . ]