User manual AUDIOVOX 1286182A

[. . . ] If the horn (or optional siren) did not sound when arming, then the chirps have been turned off. Please refer to the section titled "Eliminating the Arm/Disarm Chirps" later in this manual. The doors may or may not lock passively dependent upon the setup during installation. [. . . ] VALET / PROGRAM / MANUAL OVERRIDE SWITCH The valet switch allows you to temporarily prevent the system from arming, eliminating the need to hand your keychain transmitter to parking attendants or garage mechanics. When the system is in the valet mode, it will not passively arm or activate the starter interrupt circuit. However, all keyless entry features, as well as the remote panic feature will remain operational. The dash mounted LED will turn on solid (not flashing) indicating that the valet mode has successfully been entered. To return to the normal mode of operation, move the valet switch to the "off" position at any time the ignition switch is in the on position. Note: In the event that you lose your keychain transmitter or the transmitter fails to operate the keyless entry system, the valet switch can be used to override the optional Starter Interrupt, and therefore allow the engine to be started. LED will turn on solid. Page 3 The system will disarm, allowing the engine to be started and the vehicle to be operated normally. Always remember to move the valet switch to the off position to allow the passive arming and optional starter interrupt features to be operable the next time you park the vehicle. ELIMINATING THE LOCK/UNLOCK CHIRPS You can selectively eliminate the normal lock and unlock chirps by holding the transmitter button slightly longer when locking and unlocking. If you find this inconvenient and wish to eliminate these chirps permanently, 1. Within 10 seconds of turning off the ignition, flip the valet switch on, "off", "on", "off", "on", "off". If the chirps were on before you started, the siren will emit 2 short chirps indicating that the chirps are now off. If the chirps were off before you started, the siren will emit one short chirp indicating that the chirps are now on. REMOTE PANIC OPERATION The lock or unlock button of your keychain transmitter also serves as a panic button and will cause the vehicle horn (or optional siren) to sound on demand. To use the panic feature, you must be within the system's maximum operating range. In an emergency situation, to use the panic feature, press and hold the lock or unlock button of your keychain transmitter for 3 seconds. This will cause the lights to flash, the vehicle horn (or optional siren) to sound, and if the optional interior illumination circuit was installed, the interior lights to flash. To disengage the panic feature before the 30 seconds are up, press and hold either the lock or unlock button of your keychain transmitter for 3 seconds or press the option button momentarily. [. . . ] All doors will lock approximately 3 seconds after the vehicle's ignition switch is turned on. This is a nice feature for maintaining the personal safety of the occupants of the vehicle, in an effortless and automatic manner. When the ignition door unlocking feature is programmed, the system will cause all door locks to unlock whenever the ignition switch is turned from the on to off position. [. . . ]