User manual AUDIOVOX 1286053

[. . . ] Unauthorized antennas, modifications, or attachments could damage the transmitter and may violate FCC regulations. Normal Position: Hold the transmitter approximately 1" from your face and speak in a normal voice, with the antenna pointed up and away. -3- FUNCTION AND LOCATION OF THE CONTROLS 13 12 6 1 7 8 2 14 CHANNEL FRS CALL F 9 10 3 4 11 5 -4- 1. Monitor Button (M): Press and hold to bypass the squelch and listen to channel activity. Up Button ( ): Press this button to increase the volume or channel setting. [. . . ] Momentarily pressing either button will increase or decrease the volume level. The display will indicate "o1" (lowest setting to "o 8" highest setting). -9- Call Button (8) When the call button is pressed, the FR-1420 will transmit a 3-second ringing sound to other transceiver's tuned to the same channel. This feature can be used to signal other parties that voice communication is desired. The call icon ( ) appears on the LED display while the call tone sounds. Press and hold the CALL button and, at the same time, press and hold the Power button for at least 2 seconds. Press the Up or Down button to select one of three call ringer melodies; each melody will sound as it is chosen. Stop at the desired melody and press the Monitor (M) or PTT button to confirm your selection. Low Battery Alert ) flashes and produces When the battery level becomes low, the battery icon ( an audible tone every ten seconds. Monitor Button (M) You can monitor channel activity by pressing the Monitor (M) button (2). If pressed for more than 2 seconds, you can continuously monitor channel activity. Function Select (F) Button Pressing the Function button will allow selection of frequency channels, as well as selection of the various unit functions. Each press permits selection of the desired channel (1­14), Scan, Dual Watch, VOX, Roger Beep and Beep Tone functions. This button also activates the Key lock feature ( ) when pressed and held for more than 2 seconds. Channel Selection Press function button once until large two-digit channel display flashes. Press Up ( ) or Down ( ) buttons to select desired channel (1­14). -10- FUNCTIONS Channel Scanning Press the Function (F) button two times until the SC icon flashes. Press the Up ( ) button to enable the Scan function in the upward channel direction. Press the Down ( ) button to enable the Scan function in the downward channel direction. Once selected, the Scan icon (SC) will appear steadily on the display. While in Scan mode, the unit will pause on any active channel for 5 seconds, and then proceed to the next higher channel. The unit will scan channels 1­14 for activity and scanning will continue until the PTT, monitor, or call button is pressed. Dual Watch Mode This feature allows monitoring of two channels simultaneously. Press the Function (F) button three times until the Dual Watch icon (DW) flashes on the display. [. . . ] dated bill of sale), specification of defect(s), transportation prepaid, to the warranty center at the address shown below. The Company disclaims liability for communications range of this product. This Warranty does not apply to any product or part thereof which, in the opinion of the Company, has suffered or been damaged through alteration, improper installation, mishandling, misuse, neglect, accident, or by removal or defacement of the factory serial number/bar code label(s). THE EXTENT OF THE COMPANY'S LIABILITY UNDER THIS WARRANTY IS LIMITED TO THE REPAIR OR REPLACEMENT PROVIDED ABOVE AND, IN NO EVENT, SHALL THE COMPANY'S LIABILITY EXCEED THE PURCHASE PRICE PAID BY PURCHASER FOR THE PRODUCT. [. . . ]