User manual AUDIOVOX 1286016A

[. . . ] Before working under the vehicle, block the wheels to prevent accidental injury. Before drilling any holes in the vehicle, verify that the drill bit will not enter into the frame rail(s) of the vehicle of damage electrical wires, fuel lines, brake lines, hoses, exhaust system components or any other items that will impair that operation of the vehicle. Check under the vehicle to ensure that the holes will be in the proper locations. Also check under the carpet to ensure that there are no wiring harnesses, fuel lines, etc. [. . . ] Remove the template and replace it with the mounting plate on the floor over the drilled holes. Place the 6 floor bolts through the mounting plate and into the holes just drilled. Place 1 sealing washer (rubber side towards vehicle floor) and 1 large fender washer over each of the floor bolts and attach the floor nuts. In addition to the sealing washer, it may be desirable to place a small circle of silicon sealer around the hole under the vehicle before installing the washers and nut, to further prevent moisture from getting into the vehicle. Have the 2nd person inside the vehicle hold the floor bolts securely with the box-end wrench, while the person underneath the vehicle tightens down the floor nuts. Press the latch of the door at the rear of the console to the right and open the door. Then set the console on the mounting plate, with the slot of the console base pointing to the tongue end of the mounting plate, and the two holes in the rear of the console pointing to the two holes in the upright end of the mounting plate. Apply a firm push forward to mate the console base and the floor mounting plate, with the tongue of the mounting plate projecting into the slot of the console base. Place the console bolts through the mounting plate and into the two holes at the rear of the console base. Powering the unit (Refer to Figure 3) NOTE: Have all the wires, such as the power cord, AV cables and external antenna cable, or CATV cable, pass through the two notches at the bottom of the door. Plug the cigarette lighter cord into the 4-PIN DC input jack on the back of the console. Then reinstall the console rear door and press the latch to close the door. Plug the other end into the cigarette lighter receptacle in the vehicle. NOTE: If the unit draws in excess of 10 Amperes, the power supply will deactivate and turn off the unit. 6 DETAIL DC 12V INPUT DC 12V DOOR DOOR LATCH VIDEO L AUDIO R OUTPUT ANTENNA TERMINAL ANTENNA JACK NUT ANTENNA JACK OF FOIL DIPOLE CABLE NOTCHES Figure 3 7 H. Originally, the antenna jack of the built-in foil dipole has already been connected to the antenna terminal behind the door at the rear of the console. In case of poor images with the foil dipole, loosen the nut around the antenna jack, unplug the antenna jack, and connect the coaxial cable of an external antenna to the antenna terminal. In addition to normal broadcast reception of VHF and UHF channels, you can connect the CATV cable directly to the antenna terminal for CH1 ~ CH125 reception. Press the auto program button to automatically search and store the channels using the on-screen display. When the channel number on the screen turns from red to green, the unit starts to play the 1st channel automatically. If the picture needs to be adjusted, use the picture button to illuminate the on-screen display for contrast, brightness, color and tint in sequence, and use the volume button to adjust each function up or down. With power applied to the unit, select the AV mode by pressing the TV/AV button, and push the tape cassette gently into the compartment of the VCP. You will feel the automatic pull on the cassette as it is loaded and the VCP will go into the play mode automatically. [. . . ] Press this button once more, and the tape will rewind at a high speed with the lamp blinking more quickly. Press this button in the stop mode; the tape will rewind at a very high speed without any picture and sound. Press this button once in the (fast) forward mode; the VCP enters the reverse picture search mode and the tape will rewind rapidly with the pictures. Press this button once more, and the tape will rewind at a high speed. [. . . ]