User manual AUDIOVOX 1285883

[. . . ] Model APS-785 Owner's Manual 4 Button Remote Start Security System With Plug-In Shock Sensor & Starter Disable FEATURES: w 2 Four Button Programmable RF Transmitters w Four Channel Code Learning Receiver (capable of accepting 4 transmitters) w Anti Code Grabbing Technology w Selectable Manual Override Mode w Remote Panic in all modes w Protected Valet/Override w Remote Start Safety Control Switch w Selectable Automatic Timed Start Mode w User Programmable Manual Override Code w 7 Function LED - Arm / Disarm / Zone 1 / Zone 2 / Zone 3 / Valet / Arming w Intrusion Alert with Memory w Audible Arm / Disarm / Defective Zone / Tamper Confirmation w Instant Siren Activation All Entry Points w Starter Disable When Armed w True Last Door Arming w Defective Zone By-Pass w Active or Passive Arming Selectable w Programmable Auto Lock On / Off w Programmable Auto Unlock / Off/Drivers Door/All Doors w Programmable Door Lock Pulse Duration 1 Second / 3. 5 Seconds/1 Sec L/ Dbl. U/L w Programmable Active or Passive Door Locks w User Programmable Permanent Chirp Delete w On Command RF Chirp Delete from Transmitter Or Selectable Through Software w 6 Tone Multi Tone Siren w Car Horn Activation for additional alarm response w Additional Negative Trigger Input w RF Inhibit with ignition on w Parking Light Flasher w Remote Keyless Entry With Optional Access Guard (must have power door locks) w Illuminated Entry w Plug In Dual Stage Shock Sensor w Remote Trunk Release (must have electronic trunk release) w Multiple Vehicle Capable w Remote Power Window Roll Up w Remote Garage Door Interface w Multiple Vehicle Capable OPTIONS : CAUTION !Be certain that the vehicle is outdoors before using this or any remote vehicle starting device. A running engine produces dangerous carbon monoxide fumes which can be harmful or fatal if prolonged exposure occurs. [. . . ] If your transmitter has a sperate lock unlock buttons, pressing the unlock button anytime after the first unlock command will cause all the vehicle doors to unlock. WHILE THE SYSTEM IS SOUNDING If during a triggered state, you wish to shut off the siren without disarming your security system, simply press and release any transmitter button other than the disarm button. This action will turn off the siren yet leave the vehicle fully armed and protected. This feature is particularly useful if you are aware of children playing near your vehicle that may accidently trigger your security system. INTRUSION WARNING SIGNAL This system will inform you if an intrusion attempt has occurred while you were away from the vehicle. Upon disarm, the siren will chirp 4 times and the parking lights will flash 3 times. Enter the vehicle and before turning on the ignition switch, observe the LED flash pattern. If the LED flashes one time. . . pause, one time. . . pause etc. , then an intrusion attempt was made by impact or a strong vibration that the shock sensor detected. If the LED flashes two times. . . pause, two times. . . pause etc. , then an intrusion attempt was made to open the hood, trunk, or by an accessory triggering device. If the LED flashes three times. . . pause, three times. . . pause etc. , then an intrusion attempt was made to the vehicle doors. Note: The LED intrusion warning indications are stored in the system's memory and will be erased when the ignition switch is turned on. VALET SWITCH: The valet switch allows you to temporarily bypass all alarm functions, eliminating the need to hand your transmitter to parking attendants or garage mechanics. When the system is in valet mode, all alarm functions are bypassed, however the remote panic feature and remote door locks will remain operational. To use the valet mode, the system must first be disarmed either by using your keychain transmitter, or by activating your personalized manual override code. Page 4 1. Press and hold the valet pushbutton switch until the dash mounted LED turns on solid. To return to normal operation, press and release the pushbutton switch any time the ignition is on. NOTE : Always remember to return the vehicle to the valet off position. The unit will report the new code three times with a one second pause between each code, then the system will begin arming. If the LED flash pattern reports the previously stored code, the new code was not entered correctly. The unit will not recognize a 0 (Zero), or no digit entered in any place, units or tenths. NOTE: If 15 seconds of inactivity expire, or if the ignition switch is turned off for more then 5 seconds during any of the above steps, the unit will revert back to the last successfully stored code. Page 5 Custom Code Programming Example: To Change the code from the factory pre-assigned code of 11 to "52" you would do the following: 1. Disarm the system by use of the transmitter, or by use of the emergency override sequence. [. . . ] NOTE: The engine will stop running before the expiration of the pre-programmed run timer if you complete any of the following: 1. Press and release trunk/key button of your keychain transmitter two times within 2 seconds. OPERATING ON AUTOMATIC START UP TIMER MODE The APS-785 has the ability to automatically start the vehicle every 2 or 4 hours over a 48 hour period. This feature is especially useful in cold climates where the only means to keep the engine and engine fluids warm is to periodically start the engine. [. . . ]