User manual AUDIOVOX 1285849

[. . . ] Model AA-RS10CS Owner's Manual 3 Channel Remote Car Starter FEATURES : w 2 Three Button Programmable RF Transmitters w Three Channel Receiver (capable of accepting 4 transmitters) w Code Hopping Technology w ( + ) and ( - ) Keyless Entry Outputs w On-Board Start Relay w On-Board Accessory Relay w On-Board Ignition 1 Relay w On-Board Ignition 2 Relay w Ignition 2 Relay Selectable On or Off During Cranking w On-Board Parking Light Relay w Ignition 3 / Shock By-Pass / GM VAT Output (relay required) w Tach Signal Learning Circuit w Two ( + ) and Two ( - ) Safety Shutdown Circuits w Alarm By-Pass Output w Channel 2 Output for Remote Trunk Release (relay required) w Channel 3 Output to Control Optional Accessories w Selectable Steady or Flashing Parking Lights for Run Indication w Selectable 10 or 15 Minute Run Time w Selectable 1 Second or 3. 5 Second Door Lock Output Pulse YOUR "CODE HOPPING" TRANSMITTERS The transmitters included with your new remote start system use the most advanced and secure form of radio 1 frequency transmission available on any current automotive 2 3 remote system. Some of today's sophisticated auto thieves use a device known as a code grabber, which will receive and store the signal from your keychain transmitter, and re-transmit at a later time to disarm your system. [. . . ] As a keyless entry unit, for your convenience, the parking lights will flash once when the doors are locked and twice when the doors are unlocked. REMOTE STARTING THE VEHICLE The AA-RS10CS will not start the vehicle if any one of the following situations exists; The vehicle's hood lid is opened. To start the vehicle, press and release the second transmitter button two times within 2 seconds. The vehicle will start and remain running for the pre-programmed 10 or 15 minute run cycle. As a visual indication, the parking lights will flash or remain on depending on the setting by your installation center. When you arrive at the vehicle, turn the ignition key to the ON position (not the spring loaded start position), then step on the brake pedal to disengage the remote starter. NOTE:The engine will stop running before the pre-programmed run cycle has expired if you perform any one of the following functions; - Press and release the KEY icon transmitter button on the keychain transmitter two times within 2 seconds. - Open the vehicle's hood - Move the safety control switch to the Off position. SAFETY CONTROL SWITCH The control switch allows you to temporarily disable the remote starting function of the system and moving this switch to the Off position is recommended whenever the vehicle is being serviced. When the system is disabled, the remote door locks and optional accessories will remain operational. [. . . ] Some of the more common uses for this channel are; o Remote Trunk Release o Remote Window Closure o Remote Garage Door Interface To activate the optional accessory, press the transmitter button with the word OPTION on it. FUNCTION SETTING CHART To be completed by installer Door Lock Time Lights Run Time 3. 5 o Pulse o 10 Min. [. . . ]