User manual AUDIOVOX 1285814

[. . . ] You may find unexpected features that could mean the difference between "protected" and "fully protected". FEATURES : M Quick Disconnect Relay Sockets M Flashing Red LED Light M Pre-Wired Valet Toggle Switch M Low Current Draw M Optional Negative Horn Output (Requires Additional Relay) M Positive Siren Output for Optional Siren M Override Switch Can Be Any 12 Volt On/Off Switch Existing in the Vehicle (Brake Light, Parking Light, Turn Signal, Window Roll Up, etc. ) M Passive Arming STARTER INTERRUPT SYSTEM The Starter Interrupt System automatically prevents your vehicle from being started after your ignition key is turned off. As an option, if an attempt is made to start the vehicle, the horn or a siren will be activated if so equipped, until the AS-9950 is disarmed if using positive output. Using the negative output, the siren will turn off the moment the potential thief stops cranking the starter. OPERATION TO ARM SYSTEM: When the ignition key is turned to the "off" position, the starter interrupt system is enabled which is confirmed by a continuously flashing red LED. [. . . ] BLACK WIRE FROM VALET TOGGLE SWITCH: (Ground Input) This wire provides a path to ground for all the circuits on AS-9950. This wire should be secured to the metal ground frame of vehicle or directly to the battery ground terminal. Make sure to scrape away all dirt and grease to get good ground connection. YELLOW WIRE FROM AS-9950: (Ignition 12 Volt Input) When the ignition key is in the "off" position, the starter interrupt function is enabled preventing the vehicle from being started again. When ignition key is in the "on" position, applying 12 volts to the secret switch circuit will disable starter interrupt function. Connect this wire to an ignition wire in the car which has 12 volts in the on and crank positions of the ignition key and 0 volts when the key is off. PINK WIRE FROM AS-9950: (To Secret Override Switch) When the ignition key is in the "on" position, momentarily applying positive 12 volts to this wire will override the starter interrupt function allowing the vehicle to be started. Once the ignition key is turned to the "off" position, the starter interrupt function will automatically be enabled, preventing the vehicle from being started. A) Connect this wire to any on/off switch that when in the "on" position, positive 12 volts is applied. Some examples are the brake light switch, parking light switch, positive type doorlock switch, window roll up switch, turn signal switch, etc. Using an existing switch eliminates the need to install another switch in the vehicle. Connect this wire to any additionally installed momentary pushbutton switch that when in the "on" position, supplies positive 12 volts. B) SECRET OVERRIDE SWITCH PINK OVERRIDE WIRE +12V Page 3 WHITE/BLACK WIRE (18 GAUGE) FROM AS-9950: (Positive Horn/Siren Output) Positive Horn/Siren output: When an attempt is made to start the vehicle the optional horn/ siren will be activated the moment you start cranking the starter and will stop sounding the moment you stop cranking the starter. AS-9950 WHITE/BLACK WIRE 18G WHITE/BLACK (12 GAUGE) AND BLACK WIRE (12 GAUGE) FROM AS-9950: (Ignition Key Starter Solenoid Wires) BLACK (12 Gauge Wire ) When in the disarmed condition this wire supplies positive 12 volts to the vehicle's starter relay allowing the vehicle starter to engage. WHITE/BLACK (12 Gauge) When in the armed condition this wire supplies positive 12 volts to a relay which prevents the starter from engaging. This wire also supplies positive 12 volts from the white/black wire to the optional horn/siren output while attempting to engage the starter. The wire is connected by cutting the wire from the ignition key going to the starter solenoid. This wire contains 12 volts only when ignition key is in the "Start" position. Connect the white/black wire (12 Gauge) to the wire from the ignition key and connect the black wire (12 Gauge) to the remaining cut wire going to the starter solenoid. WHITE/BLACK WIRE (12 GAUGE) AS-9950 BLACK WIRE (12 GAUGE) IGNITION KEY X CUT WIRE BLACK/WHITE (18 GAUGE WIRE): SOLENOID STARTER This wire provides ground to sound the vehicle's horn when unauthorized attempts to start the vehicle are made when the system is armed. This wire will provide an output only if the optional relay is installed into it's socket in the relay harness. Page 4 Required Relays Optional Horn Relay AS-9950 +12 Volts Constant Red 2A FUSE Blue White/Black 12 Gauge Yellow To Starter Solenoid 2A FUSE Ignition Source Connect To +12 Volts Ignition/Crank Black 12 Gauge 2A FUSE Valet Toggle Switch Black/White Pink To Secret Override Switch (+12V when activated) Ground Output To Operate Horn White/Black (18 Gauge) (Optional Siren) Page 5 12 MONTH LIMITED WARRANTY Applies to control modules, relays, transmitters, sensors, and sirens. [. . . ] The Company does not warrant that this product cannot be compromised or circumvented. THE EXTENT OF THE COMPANY'S LIABILITY UNDER THIS WARRANTY IS LIMITED TO THE REPAIR OR REPLACEMENT PROVIDED ABOVE AND, IN NO EVENT, SHALL THE COMPANY'S LIABILITY EXCEED THE PURCHASE PRICE PAID BY PURCHASER FOR THE PRODUCT. Some states do not allow limitations on how long an implied warranty lasts or the exclusion or limitation of incidental or consequential damage so the above limitations or exclusions may not apply to you. This Warranty gives you specific legal rights and you may also have other rights which vary from state to state. U. S. A. [. . . ]