User manual AUDIOVOX 1285807

[. . . ] OWNER'S MANUAL MANUEL D'UTILISATION MANUAL DEL USUARIO ACD-16 DETACHABLE FRONT PANEL, AM/FM/MPX RADIO WITH COMPACT DISC PLAYER, CD CHANGER CONTROLS AND QUARTZ CLOCK AUTORADIO AM/FM/MPX AVEC FAÇADE AMOVIBLE, DOTÉ D'UN LECTEUR DE DISQUES COMPACTS, DE COMMANDES DE CHANGEUR DE CD ET D'UNE MONTRE À QUARTZ PANEL DELANTERO DESMONTABLE CON RADIO AM/FM/MPX, CON REPRODUCTOR Y CAMBIADOR DE DISCOS COMPACTOS Y RELOJ DE CUARZO INSTALL ALLA INSTRUCT INSTALL AT ION INSTRUC T IONS INSTALLATION INSTRUCTIONS This unit is designed for installation in cars, trucks, and vans with an existing radio opening. In many cases, a special installation kit will be required to mount the radio to the dashboard. These kits are available at electronics supply stores and car stereo specialist shops. Always check the kit application before purchasing to make sure the kit works with your vehicle. [. . . ] NOTE: To prevent an ejected disc from accidentally being damaged, always remove the disc from the unit. When taking the front panel with you, please use the supplied carrying case to protect the panel from dirt and damage. Make sure there is no dust or dirt on the electrical terminals on the back of the panel as this could cause intermittent operation or other malfunctions. OPER AT ING INSTRUC T IONS OPER AT ING INSTRUC T IONS OPER AT ING INSTRUCT IONS OPER AT ING INSTRUC T IONS OPER AT ING INSTRUC T IONS br THEFT-DETERRENT L. E. D. bs RE-SET BUTTON bq(REL) PANEL RELEASE BUTTON FRONT This button is used to release the mechanism that holds the front panel to the chassis. To detach the front panel, press the button so that the panel releases form the chassis. To re-attach the panel, press the left side of the panel in place first (left facing radio) and then press the right side of the panel until the mechanism locks it into place. Make sure the front panel is rightside-up when attaching it to the chassis as it cannot be attached when up-side down. Do not press very hard on the front panel when attaching it to the chassis. When attaching the front panel, make sure it is centered in the chassis frame and is pressed straight into position. Located on the chassis behind the front panel, a light-emitting diode (LED) will flash when the panel is removed. The flashing light serves as a visual warning to the would-be thief that the unit has been disabled by removal of the front panel. A Re-Set button is located on the front of the chassis (front panel must be removed to access the button). The re-set circuitry is provided to protect the microprocessor circuitry and should only be activated under the following circumstances as it will erase the time and pre-set memories. If there is a malfunction of any of the switches on the unit, pressing the Re-Set button may clear the system and return to normal operation. bt MANUAL TUNING CONTROL Turn this knob clockwise to tune upward in frequency on the band in use, counterclockwise to tune downward in frequency. The frequency to which you are tuned will be shown in digital form on the display panel. When tuning in a station, always adjust 8 OPERATING INSTRUCTIONS the control so that the correct broadcast frequency is shown on the display and adjust the control so that you are receiving a clear signal. If the radio is tuned offfrequency, you could experience distorted audio, noise and other reception problems. The indication AM or FM will appear on the display panel according to your selection. bu AM/FM BAND SELECTOR (BAND) co LOCAL/REPEATCONTROL(LOC/RPT) cl LEVEL METER clock. The display will return to the radio frequency indication after 5 seconds. During CD player and CD changer operation, the first press of the button will call the time display. In either case, the display will return to the disc indication after 5 seconds. This display consists of two bar segments which indicate the level of the audio signal. The number of segments present in each bar corresponds to the audio signal level (more segments equals a stronger signal). During CD Player and CD Changer operation, the display provides an indication of the audio signal level present on the CD. cp LOUD/RANDOM CONTROL During radio operation, pressing this button selects the local setting for the reception of strong signals. [. . . ] l When the vehicle warms up during cold weather or under damp conditions, moisture may condense on the lens of the disc player. Should this occur, the player will not operate properly until the moisture has evaporated. l The unit is designed with a vibration dampening CD mechanism to minimize interruption of disc play due to normal vibration in a moving vehicle. When driving on very rough roads, however, occasional sound skips may occur. [. . . ]