User manual AUDIOVOX 1285746

[. . . ] The dash mounted LED will begin flashing rapidly, indicating that the system is automatically (passive) arming. As an added convenience, the automatic passive arming will not begin until all doors and trunk lid are closed, allowing passengers to exit the vehicle at their convenience. In 30 seconds, you will hear a single, short "chirp" from the siren, and the vehicle's parking lamps will flash one time, indicating the system is ARMED. At this time, the dash mounted LED will begin to flash slowly, providing a visual indication that the system is fully ARMED. [. . . ] Since the system is programmed for passive arming, it will begin to re-arm until a door is opened. INTRUSION WARNING SIGNALS: The system will inform you if an intrusion attempt has occurred while you were away from the vehicle. If an intrusion attempt has occurred, the siren will "chirp" 4 times when disarming the system. Enter the vehicle and observe the dash mounted LED for further information. one time. . . etc. , then an intrusion attempt was made to a light activated entry point, or the plug in shock sensor was activated. If the LED is flashing two times. . . pause. . . two times. . . etc. , then an intrusion attempt was made to the hood, trunk, or any optional sensors that were added to the vehicle. If the LED is flashing three times. . . pause. . . three times. . . etc. , then an intrusion attempt was made through one of the vehicles doors. These intrusion warning indicators are stored in the system's memory, and will only be erased from memory when the ignition key is turned on. VALET / SYSTEM OVERRIDE SWITCH: The "Valet" switch allows you to temporarily bypass all alarm functions, eliminating the need to hand your transmitter to parking attendants or garage mechanics. When the system is in the valet mode, all alarm functions are bypassed, however, the remote panic feature and remote door locks (optional) will remain operational. Enter the vehicle and turn the ignition key to the "on" position. The dash mounted LED will turn on solid, and remain on as long as the system is in the valet mode. To return to normal operation, move the valet switch to the "off" position any time the ignition is on. In the event you lose your transmitter, or if the transmitter fails to disarm the system, the valet switch can be used as a system override switch. Turn the ignition key on, and move the valet switch to the "on" position. NOTE: Always remember to move the Valet Switch back to the "off" position. This will ensure that the vehicle remains protected at all times. Page 3 ELIMINATING THE ARM / DISARM CHIRPS: The normal arming and disarming confirmation "chirps" can easily be turned on and off using the valet toggle switch. Within 10 seconds of turning the ignition key off, move the valet toggle switch to the on-off-on-off-on-then off position. If, before proceeding with step 1, the chirps were on, then you will hear 2 chirps to indicate that the chirps have been turned off. If, before proceeding with step 1, the chirps were off, then you will hear 1 chirp to indicate that the chirps have been turned on. Whenever power to the system is disconnected (for repair or service of the vehicle), the chirps will be active when power is re-connected. Note: Whenever the chirps are by-passed, the 3 chirp defect and 4 chirp intrusion indicator will always operate. [. . . ] DISARM / INTRUSION PARKING LAMPS (Optional) 1 FLASH 2 FLASH 3 FLASH Your System Has These Features Activated: q Starter Cut-out q Door Lock Interface q Shock Detector q Motion Detector q Hardwire Optional Channel 2 Device © 2000 Audiovox Corp. , 150 Marcus Blvd. , Hauppauge, N. Y. 11788 128-5746 Page 5 60 MONTH LIMITED WARRANTY Applies to control modules, relays, transmitters, sensors and sirens. AUDIOVOX CORPORATION (the Company) warrants to the original retail purchaser of this product that should this product or any part thereof, under normal use and conditions, be proven defective in material or workmanship within 60 months from the date of original purchase, such defect(s) will be repaired or replaced with new or reconditioned product (at the Company's option) without charge for parts and repair labor. To obtain repair or replacement within the terms of this Warranty, the product is to be delivered with proof of warranty coverage (e. g. dated bill of sale), specification of defect(s), transportation prepaid, to an approved warranty station or the Company at the address shown below. [. . . ]