User manual AUDIO RESEARCH AR-VT130

[. . . ] • When turning off the display by detaching the power cord, wait 6 seconds before re-attaching the power cord for normal operation. • Ensure the use of an approved power cord provided by Philips at all times. If your power cord is missing, please contact your local service center. • Do not subject the display to severe vibration or high impact conditions during operation. [. . . ] Smart contrast Note: This function is not available when Light sensor or Brightness under Panel saving is turned on. Disable these functions to make Smart contrast accessible from the OSD menu. When turned on, this function helps enhance image contrast when displaying dark scenes. Smart picture Select a smart picture mode from: • Standard: for images (factory setting) • Highbright: for moving images such as Video • sRGB: for text based images • Cinema: for movies. This mode is automatically selected after you change the settings in the Picture menu. Use the UP/DOWN button to toggle between • VGA • DVI-D • Component • DisplayPort • HDMI Picture reset Reset all settings in the Picture menu. Select Reset and press the SET button to restore settings to factory preset values. Press the EXIT button to cancel and return to the previous menu. RETURN TO THE CONTENTS User Manual AR-VT130 4. 2. 2. Press the PLUS button to move the image to the right, or press the MINUS button to move the image to the left. Press the PLUS button to move the image up, or press the MINUS button to move the image down. Press the PLUS button to expand the width of the image, or press the MINUS button to shrink it. Use the UP/DOWN button to toggle between • Last status - The display will return to the previous power status (on/off/standby) when removing and replacing the power cord. • Forced on - The display will turn on when the power cord is connected to a wall outlet. • Power off - The display will remain off when the power cord is connected to a wall outlet. Note: If you unplug the power cord and re-plug within 7 seconds, the display will not work under the selected setting. Use this function to automatically optimize the VGA image within the display. Use the UP/DOWN button to toggle between • PC - Select On to let the display enter DPMS (Display Power Management Signaling) mode when no signal can be detected from the HDMI, DVI-D, and VGA inputs after three successive cycles. • Video - Select On to let the display enter power saving mode when no signal is detected from the Component input after three successive cycles. Panel saving Choose to enable the panel saving functions to reduce the risk of the "image persistence”. Use the UP/ DOWN button to toggle between • Brightness - Select On and the brightness of the image will be reduced to an appropriate level, and the Brightness setting in the Picture menu will become unavailable. • Pixel shift - Select the time interval for the display to slightly expand the image size and shift the pixel position in four directions (up, down, left, and right). Use the PLUS/MINUS button to make selection (Off-900 seconds from current time). [. . . ] Moving the display with its cables attached may damage the cables and thus cause fire or electric shock. • Disconnect the power plug from the wall outlet as a safety precaution before carrying out any type of cleaning or maintenance procedure. Front Panel Cleaning Instructions • The front of the display has been specially treated. Wipe the surface gently using only a cleaning cloth or a soft, lint-free cloth. [. . . ]