User manual AUDIO ANALOGUE PRIMO RE 1.3C

[. . . ] This equipment can't be used for different purposes other than those for which it has been manufactured. AUDIO ANALOGUE does not take any responsibilities for accidents or damages due to improper use of the equipment. WARNING Please do respect the safety standards contained in this manual before starting to operate the equipment. No further interventions than those described in this manual should be made. [. . . ] Keep the equipment far from sources of heat such as the solar light, kitchens, radiators etc. Always Switch off and unplug the supply cable before cleaning the equipment externally. If the amplifier was carried from an extremely cold environment to and extremely hot one, it could create internal condensation, causing possible bad functioning. If this occurs, please wait for at least an hour before using it again, to allow it to gradually reach room temperature. INSTRUCTIONS TO PUT IT OUT OF SERVICE Consult qualified staff Follow the regulations of the current legislation regarding recycling and waste disposal. A fix light indicates the selected source and the normal operative status of the unit, while a blinking light indicates that the unit is in the mute mode. It rotates just for a few degrees because it operates on an interrupter. Sixteen green leds around the volume knob progressively indicate the volume level. Turntable ground connector (to be used only when phono input is in use) PH/1. If one of the items listed above is missing, please contact your Audio Analogue retailer. After extracting the smallest items from the package, pull out the unit carefully. If batteries are not already placed in the remote controller battery slot, open the slot; insert batteries according to the indicated polarity, then close the battery slot. Where to place Primo Settanta Primo Settanta is a complex unit that may generate a large quantity of heat. In particular, you should leave at least 5cm around and above the unit and avoid placing it close to heat sources (radiators, heaters, amplifiers, television sets). Plugging and connecting Primo Settanta Before to connect Primo Settanta to a sound source, please be sure that they're both unplugged from wall outlets. First of all, hook up the sound sources outs to the Primo Settanta ins. as the second step , connect Primo Settanta output to the speakers cable. Notes on Primo Settanta power plugging Primo Settanta has to be plugged to the electric installation grounding link to guarantee user's safety and maximize sound quality. Actually, the grounding link is the way to eliminate noise and dispersion: that's why the power cord has the grounding prong. It is preferable not to interrupt grounding link (for example, with a two-prong adapter) unless this operation is necessary to avoid further Noise and only when Primo Settanta is hooked up to a grounded amplifier. Audio Analogue assumes no responsibility for damage or malfunctioning due to incorrect Primo Settanta power plugging. Correct power phase Due to the asymmetric structure of the power transformer winding, it is very important to correctly plug Primo Settanta according to the power phase. [. . . ] Note on Tape output Caution, when the volume is in position 0, the Tape output is disconnected Nota sull'uscita TAPE Attenzione, quando il volume è a livello'0' l'uscita TAPE è disattivata Phono board (optional) A feature that makes Primo Settanta a very flexible unit is the possibility to install a special board (1) that transforms Line input 1 into a Phono input. If you want to connect Primo Settanta to a record player, please ask for the optional phono board and install it according to the instructions below. Warnings on Primo Settanta use The volume knob doesn't operate on a potentiometer. It turns clockwise or anti-clockwise for a few degrees and goes back to the initial position when released. [. . . ]