User manual ATIKA VT 40 BROCHURE

[. . . ] Do not operate machine before having read the operating instructions, understood all the notes and assembly the machine as described here. Extent of delivery Declaration of conformity Operating times Symbols machine Symbols used in the operating instructions Proper use Residual risks Safety instructions Assembly Start-up Setting the work depth Working instructions Working with the scarifier Maintenance and cleaning Transport Storage Possible faults Technical data Description of device / Spare parts Guarantee 11 11 11 11 12 12 12 12 14 14 15 15 15 16 16 16 17 17 18 18 Herewith declare under our sole responsibility that the product Scarifier Type VT 36 and VT 40 is conform with the above mentioned EC directives as well as with the provisions of the guidelines below: 2004/108/EC, 2006/95/EC and 2000/14/EC. VT 36 Measured level of the acoustic output LWA Guaranteed level of the acoustic output LWA VT 40 After unpacking, check the contents of the box That it is complete Check for possible transport damage · Before initiating the device please observe the provisions pertaining to corresponding laws (regional provisions) for the noise control. Shut off engine and remove power cord before performing cleaning, maintenance or repair work. [. . . ] Before turning on the motor, make sure that your feet are at a safe distance from the cutting tools. If not absolutely necessary, do not tilt the device when starting the motor. Required extent and only lift the side which is averted to the operator. Pay attention to sure footing especially when working on slopes or on wet grass and keep your balance at all times. When thatching on slopes, always work perpendicular to the slope and never up and down. Be especially careful when changing the operating direction on a slope. While the motor is running, do not - lift or carry the device about - lift the impact guard Caution!Pay attention that the impact guard is closed or that the grass catching bag (optional accessory, if applicable) is attached. Turn off the device and wait until the drum has stopped when - tilting the scarifier - crossing areas not planted with grass - transporting the device to and from the work area Switch the machine off and remove the mains plug from the socket when - carrying out repair works - maintenance and cleaning - removing malfunctions and blockages - transport and storage - leaving unattended (even during short interruptions) - when the scarifier begins to exhibit unusual vibrations - when you have hit an obstacle with the scarifier. Store unused equipment in a dry, locked place out of the reach of children. Check the machine for possible damage: - Before continuing to use the machine, the protective devices must be inspected to ensure that they work perfectly and with their intended function. - Check whether movable parts function perfectly and do not stick or whether parts are damaged. all parts must be correctly installed and fulfil all conditions to ensure perfect operation. - Damaged guards and parts must be properly repaired or exchanged by a recognized, specialist workshop; insofar as nothing else is stated in the instructions for use. - Damaged or illegible safety warning labels should be replaced immediately. Maintain your scarifier with care: - Ensure that all nuts, bolts and screws are tight. Design of the connection cable according to IEC 60245 (H 07 RN-F) with a core cross-profile section of at least - 1. The motor does not reach any longer its maximal power; the function of the device is reduced. Plugs and coupler outlets on connection cables must be made of rubber, non-rigid PVC or other thermoplastic material of same mechanical stability or be covered with this material. When running the connection line observe that it does not interfere, is not squeezed, bended and the plug connection does not get wet. Regularly check the extension cables and replace them if they are damaged. Do not touch a damaged cable before it is disconnected from the mains. [. . . ] In any case, adhere to all safety notes (see "Safe working"). Clean the device carefully after each use to ensure faultless function to be maintained. Clean the housing, especially the vent slots, from grass and dirt stuck to it. Therefore set the work depth of the drum to position 6 during transport. [. . . ]