User manual ATIKA T 250 BROCHURE

[. . . ] Risk of injuries of fingers and hands by the saw blade Wear eye and ear protection Not observing this instruction can lead to injuries or cause damage to property. This information helps you to use all the functions of the chain saw optimally. The circular saw is solely intended use for the longitudinal and transverse cutting of solid timber, panel materials such as chipboard, wood core plywood, and medium density fibreboard (MDF) using HM circular saw blades, whereby only saw blades that comply with the standard EN 847 ­ 1 may be used. The use of saw blades made of HSS steel (high-alloy high speed tool steel) is not permissible, because this steel is hard and brittle. [. . . ] The use of other tools and other accessories can signify a risk of injury for you. It is set in the works so that its distance from the toothed ring above the table must Switch the machine off and remove the mains plug from the socket when - carrying out repair works - carrying out servicing and repair works, removal of faults (this also includes removing clamped splinters) - Transporting the saw - Changing the saw blade - leaving the saw unattended (even during short interruptions) Look after your saw with care: - Keep the tools sharp and clean to be able to work better and more safely. - Follow the servicing instructions and the information about changing tools. Check the machine for possible damage: - Before continuing to use the machine, the protective devices must be inspected to ensure that they work perfectly and with their intended function - Check whether the movable parts function perfectly and do not stick or whether the parts are damaged, All parts must be correctly installed and fulfil all conditions to ensure perfect operation of the saw - Damaged guards and parts must be properly repaired or exchanged by a recognized, specialist workshop; insofar as nothing else is stated in the instructions for use. Store the unused machine in a dry locked place away from the reach of children. Do not use the saw for unsuitable purposes (see 'Normal intended use'). When longitudinally cutting narrow workpieces (distance between the saw blade and the parallel rip fence less than 120 mm), use the pushstick. To push narrow workpieces against the parallel rip fence, use a pushstick. It must be adjusted so that the toothed ring is covered except for the part required for machining the workpiece. Ensure that cut off pieces are not caught up by the saw blade and projected away. Do not remove splinters, chips and waste from the hazardous area of the saw blade by hand. When cutting logs, use a special device, which secures the workpiece on both sides of the saw blade against turning. Design of the connection cable according to IEC 60 245 (H 07 RN-F) with a core cross-profile section of at least - 1. regularly check the saw cable and if damaged , have it renewed by a recognised skilled electrician. Regularly check the extension cables and replace them if they are damaged. When working outdoors, only use extension cables especially approved and appropriately labelled for outdoor use. The electrical connection or repairs to electrical parts of the machine must be carried out by a certified electrician or one of our customer service points. Local regulations ­ especially regarding protective measures ­ must be observed. Repairs to other parts of the machine must be carried out by the manufacturer or one of his customer service points. Use only original spare parts, accessories and special accessory parts. Accidents can arise for the user through the use of other spare parts. The manufacturer is not liable for any damage or injury resulting from such action. [. . . ] Commercial, small dust collectors or industrial vacuum cleaners are used for vacuuming. För att garantera klyvkilens funktion, får dess avstånd till sågbladets tandkrans över bordet uppgå till högst 5 mm. Loosen the saw blade by setting wrench 1 at the nut and loosening it in the direction shown, countering with wrench 2. Note the direction in which the saw blade turns (see arrow on saw blade). [. . . ]