User manual ATIKA SWINGLINE 2000 BROCHURE

[. . . ] - Housing box complete with drive unit - Cover - Frame - Frame bracket - Guide plate - Corrugated grid - 2 standing legs - 2 standing leg extensions - Axle - 2 wheels - 2 hub caps - Bag of screws The vibration sieve can be used in the home and garden for sieving materials to be separated (compost, top soil, pebbles/sand). Proper use includes adherence to the operating, maintenance and repair instructions of the manufacturer and observance of the safety instructions they contain. Any other utilisation counts as improper use, especially use with foodstuffs. [. . . ] Always fix tightly tilting angle control during storage, transport and operation. Set up and run the machine on a solid, level base only (where it will not tip over). Wear protective goggles and eye protection while working with the machine. Do not spray machine with water (this is hazardous due to live components). Be absolutely sure to pull the plug before: adjust the angle moving or transport cleaning, maintenance or repair work When laying the connecting attachments, be sure that they do get crushed or bent, and that the plug-and-socket connection does not get wet. A licensed professional electrician must make all electrical connections and repairs, and observe local regulations in doing so, especially those regarding protective measures. The manufacturer or a company designated by the manufacturer must attend to the repair of all electrical parts on the machine. Only use extension leads with sufficient diameters: - cable up to 50 metres: diameter at least 1, 5 mm². Before using the machine, make sure each time that - there are no faulty connections - all screws are tight - whether tilting angle control is properly tightened. Switching on and off red 0 = OFF green = ON Switch the motor on and off only at the switch. In the event of a power failure, the machine will switch off automatically. Connecting attachments must be designed in conformance with IEC 245-4:1980 (DIN 57 282) and marked H 07 RN-F, or comparable models. Use only connecting attachments with a rubber plug device that is protected against spraying water . For example, sieving - larger pieces of unrecompensed waste in the compost - stones and roots from the top soil - pebbles or rubble from sand Please note: Sieving is only effective for properly settled compost Moist to wet materials are harder to sieve than dry materials Angle The vibration sieve can be adjusted variably to different angles for various graduations of the sieved material: from 0° to 15° larger pieces from 15° to 30° medium pieces from 30° to 45° fine pieces To maintain their efficiency and a long life, observe the following: - After you have finished sieving, clean the machine. Slightly grease polished metal components with an environment-friendly spray oil as protection against corrosion. Protective devices removed for repairs must be properly remounted before starting the machine. [. . . ] Motor turns over, but does not start Motor starts, but becomes blocked on encountering even slight pressure, and is switched off via motor safety switch. Socket too far away from main connection, and cross-section of connection lead too small. Motor: Motorrating: Sieve angle: Effective sieve surface: Sieve mesh: Acoustic pressure level at work LPA: Acoustic capacity level LWA: Dimensions: Weight: AC-Motor 230 V, 50 Hz, 2800 min-1 P1 = 450 W, S 1 - 100 % ED P2 = 210 W, S 1 - 100 % ED 0 ­ 90 ° 510 x 470 mm galvanised steel grid, mesh width 10 mm 70 dB (A) 70 dB (A) length ca. [. . . ]