User manual ATIKA PROFI RW 1400-2 BROCHURE

[. . . ] The relevant accident prevention regulations for the operation as well as the other generally acknowledged occupational medicine and safety rules must be complied with. Unauth orised modifi ca tio ns on th e agitator exclude a liability of the manufacturer for damages of any kind resulting from it. Only persons who are familiarised with the device and informed about possible risks are allowed to prepare, operate and service this device. Repair works may only be carried out by us or by a customer service agent nominated by us. [. . . ] all parts must be correctly installed and fulfil all conditions to ensure perfect operation of the machine. - Damaged guards and parts must be properly repaired or exchanged by a recognized, specialist workshop; insofar as nothing else is stated in the instructions for use. Store unused equipment in a dry, locked place out of the reach of children. Even if used properly, residual risks can exist even if the relevant safety regulations are complied with due to the design determined by the intended purpose. Residual risks can be minimised if the "Safety instructions" and the "Normal intended use" as well as the whole of the operating instructions are observed. Observing these instructions, and taking proper care, will reduce the risk of personal injury or damage to the equipment. Failure to observe the safety precautions can lead to injury to the operator or damage to property. Impairment of hearing when working on the machine for longer periods of time without ear protection. In addition, in spite of all the precautionary measures taken, non-obvious residual risks can still exist. Design of the connection cable according to IEC 60 245 (H 07 RN-F) with a core cross-section of at least 3 x 1. The motor does not reach any longer its maximal power; the function of the device is reduced. Plugs and coupler outlets on connection cables must be made of rubber, non-rigid PVC or other thermoplastic material of same mechanical stability or be covered with this material. When running the connection line observe that it does not interfere, is not squeezed, bended and the plug connection does not get wet. Regularly check the extension cables and replace them if they are damaged. Only hook up the machine by means of a fault-current circuit breaker (30 mA). The electrical connection or repairs to electrical parts of the machine must be carried out by a certified electrician or one of our customer service points. Repairs to other parts of the machine must be carried out by the manufacturer or one of his customer service points. Accidents can arise for the user through the use of other spare parts. The manufacturer is not liable for any damage or injury resulting from such action. 5 m featuring a core cross section of at least 25 mm² Do not use any device where the switch can not be switched on and off. Damaged switches must be repaired or replaced immediately by the customer service. As you press more firmly on the button the rotational speed also increases. [. . . ] + Before a longer period of storage carry out the following to extend the machine's service life and ensure an easy operating: - thoroughly clean the device Before each maintenance and cleaning work: - switch off device - wait for standstill of the beater - pull out power plug Use only original parts. Maintenance and repair work beyond this is only allowed to be carried out by the manufacturer or authorized service staff. Store unused equipment in a dry, locked place out of the reach of children. Observe the following to maintain the operability of the machine: Keep vent slits clean and free from obstructions. [. . . ]