User manual ATIKA LSH 2600

[. . . ] Only persons who are familiarised with the device and informed about possible risks are allowed to prepare, operate and service this device. Repair works may only be carried out by us or by a customer service agent nominated by us. The machine may not be used in a potentially explosive environment or be exposed to the rain. Even if used properly, residual risks can exist even if the relevant safety regulations are complied with due to the design determined by the intended purpose. [. . . ] Within his area of work the operator is responsible for third parties. Children and youngsters less than 16 years of age and people who have not read the original instructions must not operate the machine. Never operate the machine if other persons are in the immediate vicinity. The user is responsible for accidents with other people or their property. Only operate the machine with complete and correctly attached safety equipment and do not alter anything on the machine that could impair the safety. Do not spray machine with water (this is hazardous due to live components). Switch the machine off and remove the mains plug from the socket when - carrying out repair works - carrying out servicing and repair works, removal of faults - checking the leads to see whether these are caught up or damaged - changing over from vacuuming to blowing - transporting - leaving unattended (even during short interruptions) - unusual noises and vibrations Thoroughly maintain your garden vac: - Make sure that the ventilation apertures are free. - Follow the maintenance instructions and the instructions for spool exchange. Check the machine for possible damage - Before continuing to use the machine, the protective devices must be inspected to ensure that they work perfectly and with their intended function - Check whether the parts are damaged. all parts must be correctly installed and fulfil all conditions to ensure perfect operation of the saw. - Damaged guards and parts must be properly repaired or exchanged by a recognized, specialist workshop; insofar as nothing else is stated in the instructions for use. - Damaged or illegible safety warning labels should be replaced immediately. Store the unused machine in a dry locked place away from the reach of children. Design of the connection cable according to IEC 60245 (H 07 RN-F) with a core cross-profile section of at least - 1. The motor does not reach any longer its maximal power; the function of the device is reduced. Plugs and coupler outlets on connection cables must be made of rubber, non-rigid PVC or other thermoplastic material of same mechanical stability or be covered with this material. When running the connection line observe that it does not interfere, is not squeezed, bended and the plug connection does not get wet. Protect the cable against heat, oil and sharp Do not use the cable to pull the plug from the socket. Do not touch a damaged cable before it is disconnected from the mains. When working outdoors, only use extension cables especially approved and appropriately labelled for outdoor use. [. . . ] Maintenance and repair work beyond this is only allowed to be carried out by the manufacturer or authorized service staff. No mains power (power failure) Connection lead defect Check fuse (10 A) Replace lead or have lead checked (electrician) Never use defect lead To solve the problem, contact the Motor or switch defect manufacturer or an authorised company (see customer service list) Material is not sucked in properly (reduced Machine is clogged or blocked Eliminate the blocking, call the service vacuuming power) if required Bag too full Empty bag Speed setting too low (only for garden vacs with fully variable speed control) Adjust to higher speed Extension cable too long, or crosssection too small. Socket too far away Extension cable at least 1, 5 mm2 , from main connection, and crossmaximum 25 m long. Model Motor power P1 Motor Speed n (with speed control) Blowing air flow (max. [. . . ]