User manual ATIKA LHF 2800

[. . . ] Danger ­ objects may be thrown out at high speed when motor is running. Switch off the motor and disconnect the mains plug before performing cleaning, maintenance or repair work. Even if used properly, residual risks can exist even if the relevant safety regulations are complied with due to the design determined by the intended purpose. Retaining basket unlocked Electrical devices do not go into the domestic rubbish. [. . . ] One moment of carelessness when using the device can result in serious injuries. Wear protective goggles, gloves and noise protection while working with the machine. Wear suitable work clothes: - do not wear loose-fitting clothes - slip-proof shoes Within his area of work the operator is responsible for third parties. The machine must not be operated by children or young people under 16 years of age. Never operate the machine if other persons are in the immediate vicinity. Only operate the machine with complete and correctly attached safety equipment and do not alter anything on the machine that could impair the safety. Do not alter the revolution speed of the motor, since this controls the safe maximum operating speed, and protects the motor and all rotating parts against damage due to excess speed. Take into consideration environmental influences: - Do not use the device in moist or wet ambience. To prevent danger of injury to fingers during assembly or cleaning operations wear protecting gloves. Switch the machine off and remove the mains plug from the socket when - Performing maintenance and cleaning work. If the machine's filling funnel or ejection slot is blocked switch off the motor and disconnect the mains plug before removing material from the filling funnel or ejection slot. Do not use any device where the switch can not be switched on and off. Damaged switches must be repaired or replaced immediately by the customer service. In case of a power failure, the device switches off automatically (zero-voltage initiator). Working with the garden shredder Choose a working position alongside the equipment or behind it. Longer material that is protruding from the device could spring back when it is drawn in by the blades!Never place hands, other parts of the body or clothing into the filler funnel, ejection channel or in the vicinity of other moving parts. Check before powering the device up that: - no material residues are in the filling hopper, - the retaining basket is locked. When filling, be careful that no pieces of metal, stones, bottles or other objects unintended for processing, enter the filling hopper. Immediately switch off the equipment and allow it to come to a stop, if foreign objects enter the filling hopper or if the equipment starts to make unusual noises or vibrates. Remove the mains plug and carry out the following checks: - inspect for damage, - replace or repair damaged parts, - check the equipment and tighten loose parts. You must not repair the equipment yourself if you are unauthorized to do so. [. . . ] - After each operation treat bare metal parts with an environment-compatible biodegradable spray oil to protect them against corrosion. - the cutting roller and shaving plate are expendable parts, though with normal use and correct adjustment they have a service life of many years. Fault Motor does not start Possible cause No power supply Mains cable defective Machine overloaded (motor protection) Remedy Check fuses have these checked (electrician) Allow the device to cool down. Shredding material is not drawn The cutting roller is running in reverse. [. . . ]