User manual ATIKA KSG 220 A BROCHURE

[. . . ] Risk of injury to fingers and hands by touching the grinding wheel in areas not covered. Danger resulting from electric current, if improper connecting wires are used. Impairment of hearing when working on the machine for longer periods of time without ear protection. In addition, in spite of all the precautionary measures taken, non-obvious residual risks can still exist. [. . . ] One moment of carelessness when using the device can result in serious injuries. - do not wear loose-fitting clothes or jewellery; they can catch in moving parts. - wear a hair-net if your hair is long Wear protective clothing: - safety goggles - ear protection (Sound intensity level at workplace can exceed 85 dB (A)) - dust mask Keep your workplace in an orderly condition!Take into consideration environmental influences: - Do not use the device in moist or wet ambience. Do not allow other persons, especially children, to touch the tool or cable. Only operate the machine with complete and correctly attached safety equipment and do not alter anything on the machine that could impair the safety. Do not use any grinding wheels which do not comply with the indicated characteristics of this instruction manual. The use of other tools and other accessories may present a risk of injury to you. Switch the machine off and remove the mains plug from the socket when - carrying out repair works - maintenance and cleaning - Elimination of failures (including freeing a blocked grinding wheel) - Storage - Leaving the chain sharpener (even in case of shortterm interruptions) Caution!Maintain your chain sharpener with care: - Keep the device free of oil and grease. - Follow the maintenance instructions and the instructions for tool exchange. Check the machine for possible damage: - Before continuing to use the machine, the protective devices must be inspected to ensure that they work perfectly and with their intended function. - Check whether the movable parts function perfectly and do not stick or whether the parts are damaged. all parts must be properly mounted and all conditions met to ensure the flawless operation of the chain sharpener. - Unless otherwise indicated in the operating instructions, damaged safety devices and parts must be properly 12 - Damaged or illegible safety warning labels should be replaced immediately. Before switching on, check always that wrenches and adjusting tools are removed. Store unused equipment in a dry, locked place out of the reach of children. Design of the connection cable according to IEC 60245 (H 07 RN-F) with a core cross-profile section of at least - 1. 5 mm² for cable lengths up to 25 m Long and thin connection lines result in a potential drop. The motor does not reach any longer its maximal power; the function of the device is reduced. Plugs and coupler outlets on connection cables must be made of rubber, non-rigid PVC or other thermoplastic material of same mechanical stability or be covered with this material. When running the connection line observe that it does not interfere, is not squeezed, bended and the plug connection does not get wet. [. . . ] Start working only after the grinding wheel has reached its maximum speed. Ensure that you always comply with the safety instructions given on p. Note the following to keep your chain sharpener functioning: Clean and oil all moving parts regularly (except for the drive system). Store unused equipment in a dry, locked place out of the reach of children. [. . . ]