User manual ATIKA GHD 2800

[. . . ] The manufacturer is not liable for any type of damage resulting from this: the user bears the sole risk. Unauthorised modifications on the garden shredder exclude a liability of the manufacturer for damages of any kind resulting from it. Only persons who are familiarised with the device and informed about possible risks are allowed to prepare, operate and service this device. Repair works may only be carried out by us or by a customer service agent nominated by us. [. . . ] If the machine's filling funnel or ejection slot is blocked switch off the motor and disconnect the mains plug before removing material from the filling funnel or ejection slot. Check the machine for possible damage: - Before further use of the machine the safety devices must be checked carefully for their proper and intended function. - Check whether movable parts function perfectly and do not stick or whether parts are damaged. all parts must be correctly installed and fulfil all conditions to ensure perfect operation of the machine. - Damaged safety devices and parts must be properly repaired or exchanged by a recognized, specialist workshop; insofar as nothing else is stated in the instructions for use. Store unused equipment in a dry, locked place out of the reach of children. Design of the connection cable according to IEC 60 245 (H 07 RN-F) with a core cross-section of at least - 1. The motor does not reach any longer its maximal power; the function of the device is reduced. Plugs and coupler outlets on connection cables must be made of rubber, plasticised PVC or other thermoplastic material of same mechanical stability or be covered with this material. When running the connection line observe that it does not interfere, is not squeezed, bended and the plug connection does not get wet. Regularly check the extension cables and replace them if they are damaged. When working outdoors, only use extension cables especially approved and appropriately labelled for outdoor use. Only hook up the machine by means of a fault-current circuit breaker (30 mA). The electrical connection or repairs to electrical parts of the machine must be carried out by a certified electrician or one of our customer service points. Local regulations ­ especially regarding protective measures ­ must be observed. Repairs to other parts of the machine must be carried out by the manufacturer or one of his customer service points. Accidents can arise for the user through the use of other spare parts. The manufacturer is not liable for any damage or injury resulting from such action. Do not place the equipment on ground which is paved or surfaced with gravel. Always maintain a safe distance (at least 2 m) from walls or other fixed objects. Before each use, check - Connection cables for defects (cracks, cuts, etc. In case of a power failure, the device switches off automatically (zero-voltage initiator). [. . . ] Switch on device to selector switch into position release the material to be shredded, remove any foreign matter. To continue work, place the direction of rotation selector switch back into position . - Push down with a branch and shred - Adjust fixed counter blade as described under , , adjusting the fixed counter blade". - Shredding material too soft or wet - Cutting roller worn Shredding material not cut cleanly Device starts but blocks under as slight load and switches off via protective motor switch. [. . . ]