User manual ATIKA FM 2

[. . . ] You may not start this device unless you have read these instructions and followed all notes therein. Extent of delivery After unpacking, check the contents for That it is complete Check for possible transport damage Report any damage or missing items to your dealer or the manufacturer immediately. - Moisture measuring device - Operating instructions Normal intended use · This moisture measuring device is only designed for measuring the moisture content of wood and building materials as well as for measuring the ambient temperature. [. . . ] Do not use the device for other than designated purposes (see "Normal intended use" and "Working with the moisture measuring instrument"). Take environmental influences into consideration: - Do not use the instrument in a humid or wet environment. - Do not use the instrument in potentially explosive atmospheres where inflammable liquids, gases or dusts are present. Keep unused instruments in a dry, locked place out of the reach of children and animals. To exclude the risk of injury always install the protective cap when the instrument is not used. Instrument in "Wood moisture mode" Material from wood such as sawn timber, paper, cardboard Moisture content in % Temperature in degrees Celsius Temperature in degrees Fahrenheit Insert the battery with the correct polarity. To prevent the instrument from getting damaged by a leaking battery remove the battery from the instrument when the instrument is not used for a longer period of time remove used up batteries without delay. Do not short-circuit, charge, open batteries and do not throw them in fire. Keep unused batteries in a dry, locked place out of the reach of children and animals. Working with the moisture measuring device: Powering up Press the key for a short time. Change to the next measuring mode by pressing the key within 3 seconds. Note: Firstly measure on dry material and then compare the values with the material to be measured to get a sense for the measured values. To be able to evaluate the moisture distribution within the material measure on different points. LOW (green) = 8 ­ <14% wood is dry and suited as firewood, no rotting MID (yellow) = 14 ­ <20 % marginal wood moisture, further checks required HIGH (red) = >20 ­ 60 % wood moisture too high, wood not suited as firewood, risk of rotting 5. [. . . ] - Nu lucrai cu acest aparat în medii unde exist pericol de explozie, în care se afl lichide, gaze sau pulberi inflamabile. Lämna inte in användbara batterier eller ackumulatorer kostnadsfritt till kommunala uppsamlingsställen eller till handlaren. Measure residual moisture in building timber and firewood, laminate, panels and other wood materials (8 ­ 60 % ± 2 %) Check moisture in walls, floors, stone floors, concrete and other construction materials (0. [. . . ]