User manual ATIKA COMPACT 100 BROCHURE

[. . . ] Set up and run the mixer on a solid, level base (where it will not tip over). Persons younger than 16 years of age are not allowed to operate the mixer. only use the mixer for the functions listed in "Correct use". Only start up the mixer if the protective devices are complete and undamaged. [. . . ] When laying the connecting attachments, be sure that they do get crushed or bent, and that the plug-and-socket connection does not get wet. Have a professional advise you regarding the composition and quality of the material being mixed. Prepared (commercially available) mixture production: Observe mixing ratio and details given by manufacturer on packaging. There is a sack opener on the safety grid which is used to tear open the packed mixture and filling the drum. Emptying the mixing drum: The drum is emptied through an opening in the base which is opened by actuating a lever. A licensed professional electrician must make all electrical connections and repairs, and observe local regulations in doing so, especially those regarding protective measures. The manufacturer or a company designated by the manufacturer must attend to the repair of all electrical parts on the machine. When setting up the machine, make sure that the mixing drum can be emptied without obstruction. The mixer should be cleaned thoroughly before long storage periods and moving parts treated with an environmentally-friendly spray oil. This lengthens the useful life of a mixer and ensures smooth operation of the device. Switching on and off Be sure that - all protective devices are on the mixer and properly mounted. In the event of a power failure, the machine will switch off automatically. Switch off machine and pull plug if you have to touch the machine (with hand, brush, scraper, rag, etc. Protective devices removed for cleaning must be properly remounted before starting the machine. Remove agitator head to clean ( Before taking a break and after finishing work, clean the mixer inside and out. Do not beat on the mixing drum with hard objects (hammer, shovel, etc. A dented mixing drum impairs mixing operations and is difficult to clean, besides. An electrical safety shutdown prevents the mixer operating while the safety grid is open. [. . . ] Only the manufacturer or companies authorised by the manufacturer may perform repair work on electrical parts or on parts which affect the space needed to mount electrical equipment. Malfunction Motor does not start up Possible cause No mains voltage The motor does not switch off when safety grid is open Machine starts up, but becomes blocked at low load and may switch off automatically Defective cable or plug Motor overloaded Temperature monitor activated Defective switch or cable in switch is not connected Safety grid is not closed Mixing apparatus blocked Too much mixture in drum Defective condenser Safety shutdown is not triggered Extension lead is too long or its crosssection is too small Socket is too far from mains connection and the connecting wire's cross section is too small Remedy Check fuse protection Have checked or replaced (electrician) Allow motor to cool down Check switch and/or replace Close safety grid Switch off machine, pull out mains plug and clean drum Actuate switch several times unsuccessful?Empty drum Send machine to manufacturer or a company designated by the manufacturer for repairs Check safety shutdown and/or re-place Extension lead must be at least 1. 5 mm² for a maximum length of 25 m; the cross-section of longer cables must be at least 2. [. . . ]