User manual ATIKA BWK 500 BROCHURE

[. . . ] Danger ­ objects may be thrown out at high speed when motor is running. Fangkorb verriegelt Switch off the motor and disconnect the mains plug before performing cleaning, maintenance or repair work. Even if used properly, residual risks can exist even if the relevant safety regulations are complied with due to the design determined by the intended purpose. Residual risks can be minimised if the "Safety information" and the "Intended usage" as well as the whole of the operating instructions are observed. [. . . ] When placing material into the shredder, always stand on the same level as the machine. When placing material into the shredder, always stand on the same level as the machine. Do not use the device when you are tired or under the influence of drugs, alcohol or medicaments. One moment of carelessness when using the device can result in serious injuries. Wear protective goggles, gloves and noise protection while working with the machine. Wear suitable work clothes: - do not wear loose-fitting clothes - slip-proof shoes Within his area of work the operator is responsible for third parties. The machine must not be operated by children or young people under 16 years of age. Physically, sensorially or mentally handicapped persons or persons who have no relevant experience and/or knowledge are not allowed to operate the device, unless a person responsible for their safety supervises them or instruct them on how to use the device. Children must be supervised to make sure that they do not play with the device. Never operate the machine if other persons are in the immediate vicinity. Only operate the machine with complete and correctly attached safety equipment and do not alter anything on the machine that could impair the safety. Do not use any device where the switch can not be switched on and off. Damaged switches must be repaired or replaced immediately by the customer service. Always maintain a safe distance (at least 2 m) from walls or other fixed objects. Before each use, check - Connection cables for defects (cracks, cuts, etc. In case of a power failure, the device switches off automatically (zero-voltage initiator). The motor is equipped with a safety switch and switches off automatically when overloaded. Use a tamper or hook to remove jammed objects from the hopper or ejection slot. In case of disadvantageous power system conditions shortterm voltage reductions can occur during the starting process of the device which can influence other devices (e. No failures are expected when the house service connection has a continuous currect-carrying capacity greater than 100 A per phase. The integrated retaining basket is equipped with a locking lever and a safety cut-out device. Power off the device before attaching or removing the retaining basket. [. . . ] Clean out the filler opening and ejection channel thoroughly if the machine becomes blocked. Before doing this, switch the motor off and disconnect the machine from the mains power supply. Please do not exceed the maximum branch diameter specified (cutting fresh wood) for your appliance ( see p. Depending on the wood's nature and freshness the maximum branch diameter the machine can process may be smaller. [. . . ]