User manual ATIKA BV 2300 BROCHURE

[. . . ] Regarded as machine for private gardens and allotments are those units which are not employed in public grounds, parks, sports grounds, and in agriculture and forestry. The manufacturer accepts no liability for any damages resulting from improper use, and any risk is in this case borne solely by the user. Danger ­ objects may be thrown out at high speed when motor is running. The intended usage also includes compliance with the operating, servicing and repair conditions prescribed by the manufacturer and following the safety instructions included in the instructions. [. . . ] Do not spray machine with water (this is hazardous due to live components). Switch the machine off and remove the mains plug from the socket when - carrying out repair works - carrying out servicing and repair works, removal of faults - checking the leads to see whether these are caught up or damaged - changing over from vacuuming to blowing - transporting - leaving unattended (even during short interruptions) - unusual noises and vibrations 10 Thoroughly maintain your garden vac: - Make sure that the ventilation apertures are free. - Follow the maintenance instructions and the instructions for spool exchange. Check the machine for possible damage - Before continuing to use the machine, the protective devices must be inspected to ensure that they work perfectly and with their intended function - Check whether the parts are damaged. All parts must be correctly installed and fulfil all conditions to ensure perfect operation of the saw - Damaged guards and parts must be properly repaired or exchanged by a recognized, specialist workshop; insofar as nothing else is stated in the instructions for use. - Damaged or illegible safety warning labels should be replaced immediately. Store the unused machine in a dry locked place away from the reach of children. Accidents can arise for the user through the use of other spare parts. The manufacturer is not liable for any damage or injury resulting from such action. Before using the shredder, make sure each time that - there are no faulty connections (tears, cuts, etc. ) - there are no damage at the machine - all screws are tight - check the hydraulic system for any possible leaks Compare the voltage given on the machine model plate e. Design of the connection cable according to IEC 60245 (H 07 RN-F) with a core cross-profile section of at least - 3 x 1. The motor will not be able to provide its maximum performance and the operation of the machine will be impaired. When laying the connecting attachments, be sure that they do get crushed or bent, and that the plug-and-socket connection does not get wet. Regularly check the extension cables and replace them if they are damaged. When working outdoors, only use extension cables especially approved and appropriately labelled for outdoor use. Only hook up the machine by means of a fault-current circuit breaker (30 mA). Thread the extension cable through the pull relief device as a loop and hang it up. Do not use any device where the switch can not be switched on and off. Damaged switches must be repaired or replaced immediately by the customer service. The electrical connection or repairs to electrical parts of the machine must be carried out by a certified electrician or one of our customer service points. Local regulations ­ especially regarding protective measures ­ must be observed. [. . . ] The guarantee only remains valid provided that original replacement parts are used. Please contact the manufacturer for recycling machines which can no longer be used. We reserve the right to make technical changes in the course of technical progress. Model Motor power P1 Motor Speed n without speed control Speed n with speed control Blowing air flow (max. [. . . ]