User manual ATIKA BIOPLUS 2400 BROCHURE

[. . . ] Regarded as garden shredders for private gardens and allotments are those units which are not employed in public grounds, parks, sports grounds, and in agriculture and forestry. Even if used properly, residual risks can exist even if the relevant safety regulations are complied with due to the design determined by the intended purpose. Residual risks can be minimised if the "Safety information" and the "Intended usage" as well as the whole of the operating instructions are observed. Risk of injury to the fingers and hands, if your hand grasps through an opening and reaches the blade unit. [. . . ] Only operate the machine with complete and correctly attached safety equipment and do not alter anything on the machine that could impair the safety. Do not alter the revolution speed of the motor, since this controls the safe maximum operating speed, and protects the motor and all rotating parts against damage due to excess speed. Do not spray machine with water (this is hazardous due to live components). Store the unused machine in a dry locked place away from the reach of children. Switch the machine off and remove the mains plug from the socket when - carrying out repair works - carrying out servicing and repair works, removal of faults - changing the blades - Transporting - leaving unattended (even during short interruptions) Check the machine for possible damage - Before continuing to use the machine, the protective devices must be inspected to ensure that they work perfectly and with their intended function - Check whether the parts are damaged. All parts must be correctly installed and fulfil all conditions to ensure perfect operation of the saw - Damaged guards and parts must be properly repaired or exchanged by a recognized, specialist workshop; insofar as nothing else is stated in the instructions for use. - Damaged or illegible safety warning labels should be replaced immediately. Design of the connection cable according to IEC 60245 (H 07 RN-F) with a core cross-profile section of at least - 1. 5 mm2 for cable lengths over 25m When laying the connecting attachments, be sure that they do get crushed or bent, and that the plug-and-socket connection does not get wet. Regularly check the extension cables and replace them if they are damaged. When working outdoors, only use extension cables especially approved and appropriately labelled for outdoor use. The electrical connection or repairs to electrical parts of the machine must be carried out by a certified electrician or one of our customer service points. Local regulations ­ especially regarding protective measures ­ must be observed. Repairs to other parts of the machine must be carried out by the manufacturer or one of his customer service points. Use only original spare parts, accessories and special accessory parts. Accidents can arise for the user through the use of other spare parts. The manufacturer is not liable for any damage or injury resulting from such action. Motor guard The motor is equipped with a guard switch and it switches off automatically when overloaded. The motor can be switched on again after a cooling-down period (approximately 5 mins. Do not place the equipment on ground which is paved or surfaced with gravel. Always maintain a safe distance (at least 2 m) from walls or other fixed objects. Before using the shredder, make sure each time that - there are no faulty connections (tears, cuts, etc. [. . . ] Branch diameter (only for freshly cut wood) 2450 2550 AH 402 AH 402 AC-Motor 230 V, 50 Hz, including automatic motor brake 2400 W 2500 W 10, 5 A 2800 min -1 motor protection switch, electrical safety cut-out, zero-voltage initiator 20 kg 20 kg 92 dB (A) measured level of the acoustic output 102 dB (A) guaranteed level of the acoustic output 103 dB (A) 40 mm 40 mm 10, 5 A The manufacturer will supply a two years warranty after supply of the machine from the dealer's store for faults in material and/or workmanship. Warranty claims, even during the warranty period, will not be accepted for damages due to incorrect handling or inadequate packaging during return of the devices or to a non-observance of the operating instructions. Faulty components should be returned to the factory, postage and freight paid. Discretion for the supply of replacements free of charge will remain with the manufacturer. [. . . ]