User manual ATIKA BIOLINE 2400 BROCHURE

[. . . ] Regarded as garden shredders for private gardens and allotments are those units which are not employed in public grounds, parks, sports grounds, and in agriculture and forestry. Declare under our sole responsibility, that the products garden shredder typ: AH 200, AH 201, AH 202, AH 203, AH 207, AH 208, AH 209, AH 210, AH 211, AH 212, AH 213, AH 214, AH 215, AH 216, AH 222, AH 223, AH 224, AH 225, AH 226, AH 227, AH 228, AH 229, AH 235, AH 236, AH 238, AH 239, AH 240, AH 241, AH 242, AH 250, AH 251 To which this declaration relates corresponds to the relevant basic safety and health requirements of the Directive 98/37/EC, and to the requirements of the other relevant Directives: 89/336/EEC; 73/23/EEC and 2000/14/EC. Measured level of the acoustic output L WA 105 dB (A) and guaranteed level of the acoustic output L WA 106 dB (A). [. . . ] Do not spray machine with water (this is hazardous due to live components). To prevent danger of injury to fingers during assembly or cleaning operations hold the cutting mechanism (for example by means of a wooden wedge, see. Only use extension leads with sufficient diameters: - cable up to 25 metres: diameter at least 1, 5 mm². Before using the shredder, make sure each time that - there are no faulty connections (tears, cuts, etc. Important: Before using the shredder for the first time, close top of case and screw tight. To maintain their efficiency and a long life, observe the following: - After shredding, the machine must be cleaned inside and outside Hedge and tree cuttings, dead flowers and vegetable kitchen waste. Glass, metal, plastic, plastic bags, stones, cloth, roots with soil, food left-overs, fish or meat. special informations on the chopping procedure: · Branches, twigs and wood should be broken down immediately after they have been cut - material of this kinds gets very hard when it is dry, and it therefore makers sense to reduce the maximum branch diameters, so that it is ready for chopping. How to chop garden and kitchen waste with hight water content and a tendency to clog - to prevent the machine from clogging, alternate waste with woodcontaining material. Please do not exceed the maximum branch diameter specified for your appliance ( see p. If the machine is overloaded, a protective motor switch ensures that the machine turns itself off automatically - turn the shredder on again after about 5 minutes - during those five minutes you cannnot turn the machine, see point 7 , , Operational faults". Please make sure, - that before closing the device, all impurities have been removed from the thread in the housing trough; impurities can block the thread so that the enclosure top of the housing does not close properly motor does not start - that the screw is screwed straight into the housing trough during closing One edge of the knife has become blunt turn knife so that you can use the other edge Both edge of the knives have become blunt replace with new set of knives (order-no. Problem Motor does not start Possible cause - no mains voltage - defective connection cable - enclosure top improperly closed (safety shut-off is activated) - cutters blocked Elimination - check fuse - have it inspected (electrician) - close and bolt down enclosure top correctly, remove any dirt present - switch machine off, disconnect mains plug, and clean interior of machine - have machine repaired by manufacturer or approved company Extension cable at least 1, 5 mm², maximum 25 m long. Motor turns over, but does not start - defective capacitor Motor starts, but becomes blocked on encountering even slight pressure, and is switched off via motor safety switch. [. . . ] Model Name Motor Motorrating P1 Motorrating P2 Input voltage Rotational speed N ca. On/off switch Weight Ecoustic pressure level at work Ecoustic capacity level measured /guaranteed max. branch diameter * Model Name Motor Motorrating P1 Motorrating P2 Input voltage Rotational speed N ca. [. . . ]