User manual ATIKA ASP 8 N-400

[. . . ] 1 ready mounted machine unit 1 control arm, right 1 control arm, left 2 wheels 1 axle 1 bag of accessories 1 operating manual Hold the work piece when splitting with the clamping claw. Vent the hydraulic system before putting the log splitter into operation. (see "Start-up") Make sure that the motor turns in the correct direction (see motor arrow), because operation in the wrong direction damages the oil pump. Read the operating and safety instructions thoroughly before commissioning the machine. [. . . ] Make sure that the oil tank cap is securely tightened to prevent oil from leaking during transport. Electrical connections must conform to IEC 60245 (H 07 RNF) with a cable cross-section of at least 400 V 3~ 5 x 1. 5 mm² for a maximum cable length of up to 10 m Never use the machine with a power supply cable of over 10 m in length. The motor will not be able to provide its maximum performance and the operation of the machine will be impaired. Plugs and coupler outlets on connection cables must be made of rubber, plasticised PVC or other thermoplastic material of same mechanical stability or be covered with this material. When running the connection line observe that it does not interfere, is not squeezed, bended and the plug connection does not get wet. Regularly check the extension cables and replace them if they are damaged. When working outdoors, only use extension cables especially approved and appropriately labelled for outdoor use. The electrical connection or repairs to electrical parts of the machine must be carried out by a certified electrician or one of our customer service points. Local regulations ­ especially regarding protective measures ­ must be observed. Repairs to other parts of the machine must be carried out by the manufacturer or one of his customer service points. Accidents can arise for the user through the use of other spare parts. The manufacturer is not liable for any damage or injury resulting from such action. Ensure that the working area meets the following conditions: - no danger of slipping - level - free of obstacles - sufficiently well lit Do not operate the machine in the direct vicinity of gas or petrol pipes or containers, or any other easily inflammable materials. Before using the log splitter, make sure each time that - there are no faulty connections (tears, cuts, etc. There are no damages at the machine all screws are tight check the hydraulic system for any possible leaks the oil level Vent the hydraulic system before putting the log splitter into operation. Unscrew venting screw by several turns so that air may escape from the oil tank. Move the splitting blade right down every time before the machine is transported. Close the venting screw before moving the log splitter, as otherwise oil will leak at this point. Never operate the machine in the event of any possible danger from hydraulic fluid. Check the hydraulic reservoir regularly to ensure that it contains enough hydraulic oil (see "Care and maintenance"). Additional SAFETY INSTRUCTIONS The log splitter may only be operated by a single person. [. . . ] Properly The log exceeds the maximum dimensions or (insufficient splitting the wood is too hard for the performance of performance). If the problem cannot be rectified, refer to the manufacturer or other approved service centre. Release rods bent (hydraulic tappet not quite Arrange for manufacturer or authorised company to pressed in). Incorrect connecting lead (longer than 10 m or Use the correct connecting lead. [. . . ]