User manual ATIKA ASP 5-UG

[. . . ] Danger of being cut or trapped; never touch any dangerous parts when the splitting wedge is in motion. Before starting any repair, maintenance or cleaning work, always switch off the motor and remove the plug from the socket. Residual risks can be minimised if the "Safety information" and the "Intended usage" as well as the whole of the operating instructions are observed. Observing these instructions, and taking proper care, will reduce the risk of personal injury or damage to the equipment. [. . . ] Use only original spare parts, accessories and special accessory parts. Accidents can arise for the user through the use of other spare parts. The manufacturer is not liable for any damage or injury resulting from such action. Connect the firewood splitter to the power supply system only after having finished the complete assembly. Assembling the stand 2 Put the middle rod (C) through the dedicated opening of the rear rod (G). Then, put the wheels (H) on the axle of the rear rod (G) on both sides. Put the rear support legs (E, F) through the dedicated openings of the rear rod (G) and tighten the hexagon screws (M8x16). Next, put the rear rod (D) on the rear support legs (E, F) and tighten also the hexagon screws (M8x16). Put the middle rods (B, C) in the dedicated opening of the front support leg (A). Electrical connections must conform to IEC 60245 (H 07 RN-F) with a cable cross-section of at least 1. 5 mm² for a maximum cable length of up to 10 m Never use the machine with a power supply cable of over 10 m in length. The motor will not be able to provide its maximum performance and the operation of the machine will be impaired. When laying the connecting attachments, be sure that they do get crushed or bent, and that the plug-and-socket connection does not get wet. Regularly check the extension cables and replace them if they are damaged. When working outdoors, only use extension cables especially approved and appropriately labelled for outdoor use. Together with the second person lift the log splitter and put it onto the stand. Make also sure that the log splitter safely rests on the front support leg (A) and rear rod (D). Put the hexagon screws (M8x100) through the hole in the front support leg (A) and the log splitter. Now, the log splitter is completely assembled on Push the green button. If you use the log splitter without frame, position the log splitter on a work surface at a height of about 60 ­ 75 cm, this will create an comfortable working position. place chocks under the wheels to prevent the machine rolling during operation. Ensure that the working area meets the following conditions: - no danger of slipping - level - free of obstacles - sufficiently well lit Do not operate the machine in the direct vicinity of gas or petrol pipes or containers, or any other easily inflammable materials. [. . . ] The use of any other type of oil will adversely affect the operation of the log splitter. Ordering spare parts: - available from the manufacturer - orders must quote the following information: · Logs are not being split properly (insufficient splitting performance) The log is not positioned correctly The log exceeds the maximum dimensions or the wood is too hard for the performance of the machine The splitting wedge is not working properly Oil leak Sharpen the splitting wedge, and check for any burrs or notches Place a sheet of cardboard under the log splitter in order to locate the leak. Check the oil level and add more oil if Hydraulic pressure too low necessary. Incorrect connecting lead (longer than Use the correct connecting lead 10 m or too small cable cross-section) Log ram travels out jerkily or under heavy Air in the circuit Open the bleed screw vibration Check the oil level and add more oil if necessary. [. . . ]