User manual ATIKA ASP 5-520 N

[. . . ] Nobody else should be in the working area of the machine other than the operator. Keep other persons or animals out of the danger area (minimum distance 5 m). Danger of being cut or trapped; never touch any dangerous parts when the splitting wedge is in motion. The log splitter is only applicable for the private utilization in the field of house and hobby. [. . . ] Electrical connections must conform to IEC 60245 (H 07 RN-F) with a cable cross-section of at least 2. 5 mm² for a maximum cable length of up to 10 m Never use the machine with a power supply cable of over 10 m in length. The motor will not be able to provide its maximum performance and the operation of the machine will be impaired. When laying the connecting attachments, be sure that they do get crushed or bent, and that the plug-and-socket connection does not get wet. Regularly check the extension cables and replace them if they are damaged. When working outdoors, only use extension cables especially approved and appropriately labelled for outdoor use. The electrical connection or repairs to electrical parts of the machine must be carried out by a certified electrician or one of our customer service points. Local regulations ­ especially regarding protective measures ­ must be observed. Repairs to other parts of the machine must be carried out by the manufacturer or one of his customer service points. Use only original spare parts, accessories and special accessory parts. Accidents can arise for the user through the use of other spare parts. The manufacturer is not liable for any damage or injury resulting from such action. Before using the shredder, make sure each time that - there are no faulty connections (tears, cuts, etc. ) - there are no damage at the machine - all screws are tight - check the hydraulic system for any possible leaks Compare the voltage given on the machine model plate e. A B C D E Log ram Bleed screw Piston rod Dipstick Cylinder cover F G H I J Electric motor Operating pushbutton Splitting wedge Log guide plates Operating lever Do not use any device where the operating pushbutton does not work properly. Position the log splitter on a work surface at a height of about 60 ­ 75 cm, this will create an comfortable working position. place chocks under the wheels to prevent the machine rolling during operation. Ensure that the working area meets the following conditions: - no danger of slipping - level - free of obstacles - sufficiently well lit Do not operate the machine in the direct vicinity of gas or petrol pipes or containers, or any other easily inflammable materials. [. . . ] Loose the operating lever as well as the operating pushbutton that the log ram can go back. Hydraulic pressure too low Check the oil level and add more oil if necessary. Incorrect connecting lead (longer than Use the correct connecting lead 10 m or too small cable cross-section) Log ram travels out jerkily or under heavy Air in the circuit Open the bleed screw vibration Check the oil level and add more oil if necessary. Log ram will not move out Hydraulic pump defective To correct the problem, refer to the manufacturer. [. . . ]