User manual ATIKA ASP 4 BROCHURE

[. . . ] The manufacturer accepts no liability for any damages resulting from improper use, and any risk is in this case borne solely by the user. Even if used properly, residual risks can exist even if the relevant safety regulations are complied with due to the design determined by the intended purpose. Residual risks can be minimised if the "Safety information" and the "Intended usage" as well as the whole of the operating instructions are observed. Observing these instructions, and taking proper care, will reduce the risk of personal injury or damage to the equipment. [. . . ] Repairs to other parts of the machine must be carried out by the manufacturer or one of his customer service points. Use only original spare parts, accessories and special accessory parts. Accidents can arise for the user through the use of other spare parts. The manufacturer is not liable for any damage or injury resulting from such action. Never try to split logs containing nails, wire or other similar objects. Never place the hands on or near any moving parts of the machine when it is switched on. Maintain a safe distance from the log, the ram and the wedge in order to protect your hands from injury. The machine should only be used for splitting logs with a maximum length of 370 mm. Before using the shredder, make sure each time that - there are no faulty connections (tears, cuts, etc. ) - there are no damage at the machine - all screws are tight - check the hydraulic system for any possible leaks Position the log splitter on a work surface at a height of about 60 ­ 75 cm, this will create an comfortable working position. place chocks under the wheels to prevent the machine rolling during operation. Ensure that the working area meets the following conditions: - no danger of slipping - level - free of obstacles - sufficiently well lit Do not operate the machine in the direct vicinity of gas or petrol pipes or containers, or any other easily inflammable materials. Never operate the machine in the event of any possible danger from hydraulic fluid. Check the hydraulic reservoir regularly to ensure that it contains enough hydraulic oil (see "Care and maintenance") Capacity: 2. The log diameter is a recommended guideline figure, because: - thin logs can be difficult to split if they contain knots or if the fibres are too strong. - logs with a diameter of over 250 mm can be split if the fibres are smooth and open. Dry logs are much easier to split, and do not cause jams as often as green (damp) wood. Wait a few moments until the motor has reached its operating revolutions and the required pressure has been built up in the hydraulic pump ­ Fig. The log ram will now return to its original starting position ­ Fig. Additional SAFETY INSTRUCTIONS The log splitter may only be operated by a single person. The machine may only be operated by persons over the age of 18 years, and who have read and understood these operating instructions. Wear protective equipment (safety goggles/mask, gloves, safety shoes) to protect yourself from possible injury. [. . . ] Electric motor defective To correct the problem, refer to the manufacturer or other approved service centre. Oil leak at the dipstick Oil seal at the dipstick not sealing Replace the oil seal. Dessutom kann det alltid finnas en viss risk att skada sig även om denna risk inte är direkt uppenbar. Innan Du trycker på elmotorns PÅ/AV-knapp måste Du se till att påskjutaren är tillbakakörd till utgångsläget. [. . . ]