User manual ATIKA ASP 10 N-400

[. . . ] According to the European Directive 2002/96/EC on electrical and electronic scrap, electrical devices that are no longer serviceable must be separately collected and brought to a facility for an environmentally compatible recycling. Nobody else should be in the working area of the machine other than the operator. Keep other persons or animals out of the danger area (minimum distance 5 m). Wear hearing protection when working with the machine to protect your hearing. [. . . ] 5 mm² for a maximum cable length of up to 10 m Never use the machine with a power supply cable of over 10 m in length. The motor will not be able to provide its maximum performance and the operation of the machine will be impaired. Plugs and coupler outlets on connection cables must be made of rubber, plasticised PVC or other thermoplastic material of same mechanical stability or be covered with this material. When running the connection line observe that it does not interfere, is not squeezed, bended and the plug connection does not get wet. Regularly check the extension cables and replace them if they are damaged. When working outdoors, only use extension cables especially approved and appropriately labelled for outdoor use. The electrical connection or repairs to electrical parts of the machine must be carried out by a certified electrician or one of our customer service points. Local regulations ­ especially regarding protective measures ­ must be observed. Repairs to other parts of the machine must be carried out by the manufacturer or one of his customer service points. Accidents can arise for the user through the use of other spare parts. The manufacturer is not liable for any damage or injury resulting from such action. Ensure that the working area meets the following conditions: - no danger of slipping - level - free of obstacles - sufficiently well lit Do not operate the machine in the direct vicinity of gas or petrol pipes or containers, or any other easily inflammable materials. Before using the log splitter, make sure each time that - there are no faulty connections (tears, cuts, etc. There are no damages at the machine all screws are tight check the hydraulic system for any possible leaks the oil level The transport closure must be replaced by the oil dipstick before start up the machine. Move the splitting blade right down every time before the machine is transported. to transport the machine , grasp the handle and tilt the log splitter slightly towards you. Make sure that the oil tank cap is securely tightened to prevent oil from leaking during transport. Oil dipstick If the hydraulic system is not vented, the trapped air will damage the seals and cause permanent damage to the log splitter. Do not use any device where the switch can not be switched on and off. Damaged switches must be repaired or replaced immediately by the customer service. Additional SAFETY INSTRUCTIONS The log splitter may only be operated by a single person. The machine may only be operated by persons over the age of 18 years, and who have read and understood these operating instructions. [. . . ] Properly The log exceeds the maximum dimensions or (insufficient splitting the wood is too hard for the performance of performance). If the problem cannot be rectified, refer to the manufacturer or other approved service centre. Release rods bent (hydraulic tappet not quite Arrange for manufacturer or authorised company to pressed in). Incorrect connecting lead (longer than 10 m or Use the correct connecting lead. [. . . ]