User manual ATIKA ALH 2500

[. . . ] Risk of injury to the fingers and hands, when carrying out assembly work and cleaning on the blade unit. Impairment of hearing when working on the machine for longer periods of time without ear protection. In addition, in spite of all the precautionary measures taken, nonobvious residual risks can still exist. Diameter (depending on wood species and freshness) - wilted, moist garden refuse that has already been stored for several days, alternating with branches Shredding of glass, metal, plastic parts, plastic bags, stones, fabric cut-offs, roots with soil, waste without solid consistency (e. [. . . ] If the machine's filling funnel or ejection slot is blocked switch off the motor and disconnect the mains plug before removing material from the filling funnel or ejection slot. Check the machine for possible damage: - Before further use of the machine the safety devices must be checked carefully for their proper and intended function. - Check whether movable parts function perfectly and do not stick or whether parts are damaged. all parts must be correctly installed and fulfil all conditions to ensure perfect operation of the machine. - Damaged safety devices and parts must be properly repaired or exchanged by a recognized, specialist workshop; insofar as nothing else is stated in the instructions for use. Store unused equipment in a dry, locked place out of the reach of children. Plugs and coupler outlets on connection cables must be made of rubber, plasticised PVC or other thermoplastic material of same mechanical stability or be covered with this material. When running the connection line observe that it does not interfere, is not squeezed, bended and the plug connection does not get wet. Regularly check the extension cables and replace them if they are damaged. When working outdoors, only use extension cables especially approved and appropriately labelled for outdoor use. Only hook up the machine by means of a fault-current circuit breaker (30 mA). The electrical connection or repairs to electrical parts of the machine must be carried out by a certified electrician or one of our customer service points. Local regulations ­ especially regarding protective measures ­ must be observed. Repairs to other parts of the machine must be carried out by the manufacturer or one of his customer service points. Accidents can arise for the user through the use of other spare parts. The manufacturer is not liable for any damage or injury resulting from such action. Do not place the equipment on ground which is paved or surfaced with gravel. Always maintain a safe distance (at least 2 m) from walls or other fixed objects. Before each use, check - Connection cables for defects (cracks, cuts, etc. Design of the connection cable according to IEC 60 245 (H 07 RN-F) with a core cross-section of at least - 1. The motor does not reach any longer its maximal power; the function of the device is reduced. Only actuate the direction of rotation selector switch while the shredder is switched off. [. . . ] Branch diameter (only for freshly cut wood) Safety class Protection class Mains fuse Switzerland UK 16 A time-lag 10 A time-lag 13 A time-lag 16 A time-lag 10 A time-lag 13 A time-lag max. Fault Motor does not start Possible cause - No power supply - Mains cable defective - Machine overloaded (motor protection) Remedy - Check fuses - have these checked (electrician) - Allow the device to cool down. Switch on device to release the material to be shredded, remove any foreign matter. To continue work, place the direction of rotation selector switch back into position - Shredding material too soft or wet - Cutting roller worn . [. . . ]