User manual ATIKA 2300 W

[. . . ] Unauthorised modifications on the garden shredder exclude a liability of the manufacturer for damages of any kind resulting from it. Only persons who are familiarised with the device and informed about possible risks are allowed to prepare, operate and service this device. Repair works may only be carried out by us or by a customer service agent nominated by us. Carefully read the operating manual and the safety instructions before starting the machine and observe the in- structions when operating. [. . . ] Do not alter the revolution speed of the motor, since this controls the safe maximum operating speed, and protects the motor and all rotating parts against damage due to excess speed. Take into consideration environmental influences: - Do not use the device in moist or wet ambience. To prevent danger of injury to fingers during assembly or cleaning operations wear protecting gloves. Switch the machine off and remove the mains plug from the socket when - Performing maintenance and cleaning work. If the machine's filling funnel or ejection slot is blocked switch off the motor and disconnect the mains plug before removing material from the filling funnel or ejection slot. Check the machine for possible damage: - Before further use of the machine the safety devices must be checked carefully for their proper and intended function. - Check whether movable parts function perfectly and do not stick or whether parts are damaged. all parts must be correctly installed and fulfil all conditions to ensure perfect operation of the machine. - Damaged safety devices and parts must be properly repaired or exchanged by a recognized, specialist workshop; insofar as nothing else is stated in the instructions for use. Store unused equipment in a dry, locked place out of the reach of children. Design of the connection cable according to IEC 60 245 (H 07 RN-F) with a core cross-section of at least - 1. The motor does not reach any longer its maximal power; the function of the device is reduced. Plugs and coupler outlets on connection cables must be made of rubber, plasticised PVC or other thermoplastic material of same mechanical stability or be covered with this material. When running the connection line observe that it does not interfere, is not squeezed, bended and the plug connection does not get wet. Regularly check the extension cables and replace them if they are damaged. When working outdoors, only use extension cables especially approved and appropriately labelled for outdoor use. Only hook up the machine by means of a fault-current circuit breaker (30 mA). The electrical connection or repairs to electrical parts of the machine must be carried out by a certified electrician or one of our customer service points. Local regulations ­ especially regarding protective measures ­ must be observed. Repairs to other parts of the machine must be carried out by the manufacturer or one of his customer service points. Accidents can arise for the user through the use of other spare parts. The manufacturer is not liable for any damage or injury resulting from such action. [. . . ] - Close and bolt down upper part of the enclosure correctly, remove any dirt present. - Lock the retaining basket - Switch machine off, disconnect mains plug, and clean interior of machine. Device starts but blocks Extension cable too long, or cross-section Extension cable at least 1. Socket too far from mains sup- longer cable is used, minimum cross-section 2. [. . . ]