User manual ASTRALPOOL POOL PUMPS

[. . . ] - All assembly and maintenance work must be carried out by qualified and authorised personnel who have carefully read the installation and service instructions. - To guarantee safety when operating the machine, you must comply with that set out in the installation and service instructions. - When connecting the electrical wiring to the machine motor, check the layout inside the connection box and make sure there are no pieces of wiring inside after it has been closed and that the earthing conductor is correctly connected. connect the motor in line with the wiring diagram attached to the machine. [. . . ] Due to the complex nature of the cases treated, the installation, user and maintenance instructions contained in this manual do not seek to examine all possible and imaginable cases of service and maintenance. Should you require additional instruction or have specific problems, please do not hesitate to contact the distributor or the machine manufacturer directly. - Our pumps may only be assembled and installed in pools or ponds that are compliant with HD 384. The pumps are fitted with a pre-filter with a basket inside to collect any large particles, as they may damage the hydraulic part inside the pump. - All pumps are fitted with a foot with two holes in it to anchor it to the ground (Fig. - To connect the piping, glue the pipes and the connectors, supplied together with the pump; the fitting connections to the suction and return ports on the pump are threaded and include seals to prevent water loss (Fig. - Fit the return pipes completely perpendicular and centred in relation to the port to be connected to prevent the pump and the pipe from being subjected to external stress that, apart from making fitting difficult, could break them (Fig. - To ensure the pump works correctly, prime the pump pre-filter until water rises up through the suction pipe (Fig. - Fit the pump underneath the water level in the pool to improve pump performance. - Where a self-priming pump is to be fitted above the water level, the difference in height must be no more than 2 metres (Fig. 4), ensuring that the suction pipe is as short as possible as a long pipe would increase drainage times and load losses in the installation. - Make sure that the pump is safe from possible flooding and receives dry ventilation. - The electrical installation must include a multiple separation system with contact openings of at least 3 mm. If you use a flexible cable to connect to the mains, it must have cable lugs to connect to the terminals of the pump motor. Installation with a switch is sufficient, in line with the "Mains connections" diagram. The adjustment data for the thermal relay is to be used as a guideline, as the motor is already fitted with protection. For 230 V, use a H07 RN-F3 type connection sleeve with a cable section that adapts to the power of the motor and to the length of the cable. For pumps with a three-phase motor: Use a motor guard with magneto-thermal protection. Protect the pump against overloads with a cut-off switch for the motor. For the connection (3 x 230 V network), use the protection with the highest indicated value. For the connection (3 x 400 V network), use the protection with the lowest indicated value. connect the lowest voltage at and the highest at for voltage intervals other than 230/400 V; 400/690 V. [. . . ] - Every time the pre-filter is opened, clean the seal and its seating of any impurities to ensure airtightness when the cap is closed (Fig. - Pump components that, due to their normal use, suffer wear and/or tear must be regularly replaced to ensure good pump performance. The following table shows the perishables and/or consumables used in the pump and their estimated working life. 1 year 1 year 1 year The estimated working life of the parts above has been established according to normal product use and installation conditions. [. . . ]