User manual ASKO D1996

[. . . ] There cannot be any electrical connections in this area. *24" from fill strip to fill strip. **23-7/16" depth includes space for high-loop drain hose. For standard NON-raised panels, use 1/16" up to 1/4" material. For custom raised panels, the decor trim will accept up to 1/4" flange. [. . . ] It is not recommended that the baseboard running in front of the unit and the cabinets be one continuous piece. Should the unit ever have to be removed, it is much easier if the baseboard in front of the dishwasher can be removed separately. These units have a special locking system so they can be installed with a custom panel. This panel can match the cabinets, with a drawer front, a cabinet door and matching hardware. The dishwasher's door is pre-drilled for the panel's mounting screws. The Turbo Fan Interval Drying System's vent is adjustable and must extend below the custom panel. The lower access panel has been eliminated to give the unit its single door appearance. See the Dishwasher Installation Instructions for detailed information. 9 4" Toe Kick Installations ­ D1796FI and D1996FI with Custom Panel Door Where the custom panel's height matches the dishwasher's door, a 2" decorative fill strip or cutting board must be used to fill the area between the panel and the counter top (A). For this installation, the custom door panel dimensions are 23-1/2" wide x 28-1/8" high. The opening width is 23-3/4", 3/8" narrower than standard domestic dishwashers. (A) 2" decorative fill strip or cutting board required There will be a 1-3/4" height difference between controls and panel. (B) 28-1/8" 23-1/2" 4" Custom panel extends 2" beyond/above dishwasher door. Custom panel goes from toe kick to counter top: 23-1/2"w x 30-1/8"h. 30-1/16" 23-1/2" 4" 23-3/4" Another installation option for 4" toe kick cabinets is to extend the door panel 1-3/4" above/beyond the control panel (B). This door panel is 23-1/2" wide x 30-1/8" high (two inches higher than previous option). This also means a 2" support strip must be installed between the tank and the counter top to fill the gap. Even though, like all ASKOs, the D1796FI and D1996FI can be mounted with screws going through the sides, this support strip can also be used for anchoring the unit from the top. A popular and more finished looking installation is to use the metal top fill strip shown in Dishwasher Accessories (page 7). [. . . ] The custom panel attaches to the dishwasher door via four screws that are invisible when the door is closed. Spacers allow the control panel height to be increased up to 1-7/16" so it matches the cabinet drawers. When used with custom panels, the panel's height must be reduced by the height of the spacers. Electrical And Water Requirements ­ All Dishwashers Electricity and water can enter the opening on either side within an area 4" from the back and 8" from the floor. [. . . ]