User manual ASKO D1976 QUICK START GUIDE

[. . . ] When you press a touchpad, a red indicator light at the upper left of the touchpad glows to show that you selected that program or option. After you've selected the desired wash program and options, press Start. Touchpad Controls Press these touchpads to select programs and options. Indicator Lights These lights glow red to indicate which program and options you have selected. [. . . ] Fan cool Activates the fan for an additional 30 minutes after the drying cycle to cool the dishes. Temp Lets you select the water temperature for the wash programs (except Rinse). Refer to "Temperature Options" on the next page for a conversion table. Start After you've selected your wash program and options, press this touchpad to start the dishwasher. If you've started the dishwasher then decide to change a program or an option, press and hold Start for five seconds to cancel the program and stop the machine. Make your new selections and press Start again. PROGRAM MEMORY When you select the Pans/Sani, Super, or Normal wash program, the dishwasher retains the settings until you change them. If you want to use a different wash program or option, press the touchpad(s) for the desired selections, then press Start. QUICK START PROCEDURES 1. Simply scrape off large food particles before you load the dishware. ) 2. After you've pushed the baskets back inside the unit, manually rotate the upper and lower spray arms to be sure they turn freely. The dishwasher will start. Refer to this page in the Use & Care Guide. 3, 4 3 5, 6 4, 5 UNDERSTANDING THE INDICATOR LIGHTS When the dishwasher has finished, all of the indicator lights will come on. W h e n you open the door, the indicator light for the wash program you last used will come on. If you used the high temperature options and the heat dry option, those lights will come on, too. If all of the lights on the control panel flash in sequence, this means the machine has detected an overfill. (See page 7. ) Should this happen, call the ASKO Advisory Center. LED WINDOW DISPLAYS Temperature Settings The wash programs (except Rinse) have water temperature options, as shown in the table below. Once you select a temperature, it will remain selected until you change it (except the Light and Quick wash programs, which revert to 130° F). We recommend that you use the lower temperature settings whenever possible to conserve energy. Wash Program Pans/Sani, Super & Normal Light & Quick 55° C (130° F) 45° C (110° F) Temperature Options 65° C (150° F) 55° C (130° F) 70° C (160° F) 65° C (150° F) 75° C (170° F) Program Time When a program starts, the LED displays the time it took that program to run last time. [. . . ] NOTE: When the LED displays three dashed lines, this simply means the door isn't closed completely. AMOUNT OF DISHWASHING DETERGENT TO USE We recommend that you use only unscented, granular automatic dishwashing detergent. Generally, one tablespoon of detergent is needed for a normal wash load. Also, the amount of detergent needed can vary due to differences in water hardness. [. . . ]