User manual ASKO D1796FI QUICK START GUIDE

[. . . ] To select a wash program or option, simply press the appropriate touchpad. When you press a touchpad, a red indicator light at the upper left of the touchpad glows to show that you selected that program or option. After you've selected the desired wash programs and options, press Start. [. . . ] The indicator lights will flash rapidly, alternating from left to right. (See also "Understanding the Indicator Lights" on the next page. ) PROGRAM MEMORY If you select the Pans/Sani or Normal wash program, the dishwasher retains the setting until you change them. So when you turn the machine on the next time, the indicator lights for the program and options you last used will be lit. If you want to change the settings, press the touchpad(s) for the other program or options you want to use, then press Start and close the door. Refer to your Use and Care Guide for additional information. QUICK START PROCEDURES Refer to this Refer to this page in the Use & page in Care Guide. After you've pushed the baskets back inside the unit, manually rotate the upper and lower spray arms to be sure they turn freely. The panel lights will flash rapidly left to right to indicate the unit is ready. (You should hear it click shut. ) The dishwasher will start. 3 5, 6 4, 5 CHANGING A PROGRAM AFTER YOU'VE STARTED THE UNIT The dishwasher is programmed to stop operating if the door is opened during a cycle. If you want to change a program or option after you start the machine, open the door slightly to let the spray arms stop rotating and avoid getting sprayed with water. Press and hold Start for five seconds to cancel the current selection then press the touchpad(s) for your desired selection. The drain pump will run to remove any dirty water from the dishwasher before starting the newly selected cycle. UNDERSTANDING THE INDICATOR LIGHTS When you press Start, the indicator lights will flash rapidly, alternating between the four lights on the left and the four on the right. If you open the door and the lights flash, the program has not finished. When the dishwasher is done, the indicator lights will come on for the last wash program and options that you used. (NOTE: The machine will not retain the Rinse or Quick program; it will revert to the Normal wash program. ) AMOUNT OF DETERGENT TO USE We recommend that you use only unscented, granular automatic dishwashing detergent. Generally, one tablespoon of detergent is needed for a normal wash load. Also, the amount of detergent needed can vary due to differences in water hardness. (See page 5. ) In any case, you should never use more than three tablespoons of detergent. TEMPERATURE OPTIONS You can select high or low water temperatures for the wash programs (except Rinse). [. . . ] If this doesn't resolve the problem, call the ASKO Advisory Center. You may be using too much detergent or washing your dishes in water that is too hot. (See pages 5 and 8. ) It's normal to have some water left in the sump area near the drain. [. . . ]