User manual ASKO 9603 QUICK START GUIDE

[. . . ] The power must be on before you can start the machine. Star t Button This button starts the dryer. If you open the door during a program, the dryer will stop tumbling automatically. [. . . ] If you open the door during a program, the dryer will stop tumbling automatically. To continue the program, close the door and press Start. Timer Control Use this knob to set the number of minutes you want to dry the laundry. It is best to select a shorter time; then if the load isn't dry, you can set the timer for a f ew more minutes. Air . luff Program The Air Fluff program is designed to shake dust out of fabrics, air them, or soften them. Temperature Control Normal Low Air . luff This setting does not activate the heating element. It simply circulates the air as the dryer tumbles to shake out the dust and refresh the clothes. This temperature setting should be used for heavier fabrics, such as denim, cotton, linen, etc. This temperature setting should be used for lighter, more delicate fabrics, such as synthetics. Options Buzzer Anti-crease You have the option to turn the buzzer on or off. To cancel a program, turn the Timer Control knob clockwise until the dryer stops or press the Power button to turn off the power. CLEANING THE LINT . ILTER Although the lint in your ASKO dryer will be minimal, the lint filter should be cleaned after each load to ensure maximum air flow and prevent possible overheating. Push the holder in until it snaps into place. NOTE: We recommend that you clean the lint filter after every load. EMPTYING THE CONDENSATION WATER CONTAINER If the dryer is not installed to pump out the condensed water into a drain or sink, you should empty the water container every three to five dryer loads, depending on the spin speed you use when you wash the clothes. For example, clothes spun at 800 rpm will have more moisture when you take them out of the washer than clothes spun at 1400 rpm. It may be a few minutes before the machine starts because it drains the excess water from the sump before it restarts. NOTE: Do not remove the water container while the machine is running. Simply pull out the container and pour out the water. OVERHEATING PROTECTION The dryer has a protection device that shuts the machine off if the temperature becomes too high. Overheating could occur if the lint filter is clogged or the fan or condenser unit needs to be emptied or cleaned. [. . . ] NOTE: Do not remove the water container while the machine is running. Simply pull out the container and pour out the water. OVERHEATING PROTECTION The dryer has a protection device that shuts the machine off if the temperature becomes too high. Overheating could occur if the lint filter is clogged or the fan or condenser unit needs to be emptied or cleaned. [. . . ]