User manual ASK PROXIMA ULTRALIGHT DS2

[. . . ] Digital Light Processing is a trademark or registered trademark of Texas Instruments. Adobe and Acrobat are trademarks or registered trademarks of Adobe Systems Incorporated. InFocus, In Focus, and INFOCUS (stylized) are either registered trademarks or trademarks of InFocus Corporation in the United States and other countries. FCC Warning This equipment has been tested and found to comply with the limits for a Class A digital device, pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference when the equipment is operated in a commercial environment. [. . . ] When disposing of the batteries, be sure to do so in an environmentally proper manner. To operate, point the remote at the front of the projector (not at the computer). Press the remote's Power button to turn the projector on and off (see page 9 for shutdown info). Press the remote's Menu button to open the projector's menu system. Use the arrow buttons to navigate, and the Select button to select features and adjust values in the menus. If you connect the USB portion of the M1-DA computer cable (page 5) you can use the up and down arrow navigation buttons to advance slides in a PowerPoint presentation. Troubleshooting the remote · · Make sure the batteries are installed in the proper orientation and are not dead. Make sure you're pointing the remote at the projector or the screen, not the computer, and are within the remote range of 15 feet (4. 5m). For best results, point the remote at the projector. navigation buttons 17 Optimizing computer images After your computer is connected properly and the computer's image is on the screen, you can optimize the image using the onscreen menus. · · · · · Adjust the Keystone, Contrast, or Brightness in the Picture menu. Adjust the Phase, Tracking, or Horizontal or Vertical position in the Advanced menu. Contrast: controls the degree of difference between the lightest and darkest parts of the picture and changes the amount of black and white in the image. Color: (video and component sources only) adjusts a video image from black and white to fully saturated color. Tint: (NTSC video sources only) adjusts the red-green color balance in the image. Auto Image: resynchs the projector to the source. Aspect Ratio Aspect Ratio: Aspect ratio is the ratio of the image width to image height. The default is 4:3, which displays the input resized up or down to fill the display area. The aspect ratio selection is saved for each source. 20 Presets: Presets are provided that optimize the projector for displaying computer presentations, film images, and video images. Film input is material originally captured on a film camera, like a movie; video input is material originally captured on a video camera, like a TV show or sporting event. To set a preset for the current source, adjust the image, select Save Settings in the Presets menu, then select Save User 1 (or 2 or 3). You can recall these settings in the future by selecting the User 1 preset. If you make any adjusts the image, Presets Off will automatically be selected in the Preset menu to indicate changes have been made. To restore the factory default settings, choose Factory Reset in the Settings>Service menu. Presets 21 Advanced settings The following 4 options are for computer and component sources only. [. . . ] Service Code: only used by authorized service personnel. Language Service menu 25 Maintenance Cleaning the lens 1 Apply a non-abrasive camera lens cleaner to a soft, dry cloth. Avoid using an excessive amount of cleaner, and don't apply the cleaner directly to the lens. Abrasive cleaners, solvents or other harsh chemicals might scratch the lens. Using the security lock The projector has a security lock for use with a cable lock system. Refer to the information that came with the lock for instructions on how to use it. 2 Lightly wipe the cleaning cloth over the lens in a circular motion. If you don't intend to use the projector immediately, replace the lens cap. Cleaning the lamp filter screens In dirty or dusty environments, the dust filter screens on and around the lamp module can become clogged, causing high temperatures inside the lamp module. [. . . ]