User manual ASK PROXIMA IMPRESSION 960

[. . . ] USER GUIDE IMPRESSION 960 Not the actual front page 801. 230 USG/960/AE-C 18. 09. 96 USER GUIDE IMPRESSION 960 USER GUIDE LCD PROJECTOR 2 USER GUIDE LCD PROJECTOR TABLE OF CONTENTS 1 SYMBOL DESCRIPTIONS . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 5 2 SAFETY INSTRUCTIONS. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 5 3 INTRODUCTION. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 9 4 MAIN FEATURES . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . [. . . ] The figure shows the different keys on the remote control. Set-up should be performed once with the application(s) and computer you are running most frequently. Most settings will automatically be memorized individually for each source for future use. 18 USER GUIDE LCD PROJECTOR The 'MEM' column in the tables below indicates whether the setting is memorized for each source. BATMOUSE KEYS : CONTROL FUNCTION CONTR Contrast (ratio between light and dark colors) BRIGHT Brightness (whiteness) TUNE Adjusts the stability of the image ON/OFF Turns the projected image on/off RESET Defaults to standard settings SOURCE 1 Selects RGB input source 1 as active SOURCE 2 Selects RGB input source 2 as active SOURCE 3 Selects RGB input source 3 as active FREEZE Holds the image displayed BLANK Blanks the screen REAR Mirrors the image for rear projection FREQ Adjusts the video frequency POSITION Controls the image positioning with cursor keys SCALE Selects direct mapping (1:1) or scaling of image PAN Allows panning within oversized images using cursor keys. OSD Toggles the OSD on and off CURSORS The four cursor keys control the computer mouse RIGHT This key emulates the right mouse key DRAG This key emulates the drag function LEFT This key emulates the left mouse key and is also used to execute menu commands "MEM" YES YES YES NO NO NO NO NO YES YES YES NO NO - 19 USER GUIDE LCD PROJECTOR 8. 4 CONTROL PANEL The control panel keyboard consists of a subset of the remote control keys. For a detailed overview, please see the Features section. ON/OFF TUNE BRIGHT RESET CONTROL TUNE BRIGHT RESET ON/OFF MASTER RESET FUNCTION Adjusts the stability of the image Adjusts the brightness (whiteness) of the image Defaults to factory settings Activity indicator Press all 4-key simultaneously to activate the master reset 20 USER GUIDE LCD PROJECTOR 8. 5 CONNECTORS All connectors are positioned on the left hand side of the LCD projector (seen from the rear). See the technical data section for pinouts of the various connectors. Do not connect any other devices with similar plugs to the connectors of the LCD projector, as this voids any warranty and may cause permanent damage to the device. CONNECTOR SOURCE 1 SOURCE 2 SOURCE 3 MOUSE FUNCTION Analog RGB input/output source 1 Analog RGB input/output source 2 Analog RGB input/output source 3 Universal mouse connector 21 USER GUIDE LCD PROJECTOR 9 FEATURES The LCD projector has a variety of different features implemented. 9. 1. 1 INTELLIGENT SAFECOOL SYSTEM The fan operates as long as the LCD projector is switched on. Provided that the power cord is connected, the fan continues to run for 2 minutes even after the unit has been switched off. This ensures a continuous protection against high temperature inside the projector. If the air flow is blocked, a temperature safety fuse will automatically shut off the projector to protect it from overheating. 9. 1. 2 SET-UP MEMORY The user controlled set-up, that usually is done when the projector is connected to a new computer, is automatically memorized for future use. The set-up information is stored in a non-volatile memory approximately 5 seconds after the last key is pressed. Some sources are predefined, while the remaining are available for customer set-up. Custom sources are added to the memory only if their sync pattern differs from any of the previous selections. Most settings are stored individually for each mode, including contrast, brightness, tune etc. OSD SYSTEM The OSD (On Screen Display) system echoes on screen your keypad or remote control actions. The OSD may be switched off and on by pressing the OSD key on the remote control. 22 USER GUIDE LCD PROJECTOR 9. 1. 3 CONTRAST The contrast of an image is defined as the relation between dark and light colors. An image of high contrast is often regarded as ` hard' as compared , to the ` soft'feeling of a low contrast image. Low contrast is recommended for long term viewing, while high contrast is used to enhance details. An unstable image can be seen as sideways instability or " swimming" Press TUNE until a stable image is . Observe that TUNE only works provided the FREQUENCY setting is correct. [. . . ] Should condensation appear, leave the unit in a controlled environment within operating conditions, until the condensation has evaporated, before operating the unit. 13. 1. 1 POWER SUPPLY 115 VAC 50 - 60 Hz 230 VAC 50 - 60 Hz 115 VAC - 10A/250VAC 230 VAC - 10A/250VAC 115VAC - 9 A 230VAC - 5 A DUAL VOLTAGE FUSE CURRENT 32 USER GUIDE LCD PROJECTOR 13. 1. 2 SIZE DISPLAY UNIT 322 x 245 x 638 12. 7 x 9. 6 x 25. 1 inch 12, 5 kg 27, 5 pounds 303 - 335 mm VARIOFOCUS 8 degrees 575 W Dual Ended Metal Halide OSRAM 575W/GS Active matrix TFT stripe configuration 16. 7 million 30 ms 100:1 1024 x 768 x 3 (RGB) 10 " Microsoft two key compatible serial (9 pin) PS/2 compatible two key Macintosh ADB compatible one key 14 ~ 140 MHz 15 ~ 100 kHz 56 ~ 100 Hz (VGA, S-VGA, XGA, S-XGA, Workstations) 50 ~ 60 Hz (VIDEO) 66 Hz/75 Hz (MACII) 0 ~ 1 Vpp Maximum 25 (black, red, green or blue) WEIGHT PROJECTION LENS ANTI KEYSTONE PROJECTION LAMP LCD CELL COLOR RESOLUTION RESPONSE TIME CONTRAST RATIO PIXEL RESOLUTION LCD DIAGONAL MOUSE COMPATIBILITY VIDEO FREQUENCY HORIZONTAL SYNC VERTICAL SYNC RGB INPUT DEFECTIVE PIXELS 13. 1. 3 REMOTE CONTROL Infrared wireless remote control. BATTERIES RANGE 2 pcs LR03/AAA 1. 5V penlight 7m 23 feet 33 USER GUIDE LCD PROJECTOR 13. 1. 4 COMPATIBILITY The unit is compatible with the following interfaces. Some sources are predefined, but as different varieties of these exist (especially in workstations), a frequency adjustment may be needed. MODE GENERIC RESOLUTION 640x350 640x400 640x480 720x480 800x600 1024x768 1152x900 1280x1024 640 x 350 640 x 400 640 x 480 720 x 400 800 x 600 1024 x 768 640 x 480 832 x 624 1024 x 768 1152 x 870 1024 x 768 1152 x 900 1024 x 768 1280 x 1024 1024 x 768 1280 x 1024 1024 x 768 1280 x 1024 1024 x 768 1024 x 768 MAX VERTICAL FREQUENCY 85 Hz 85 Hz 85 Hz 85 Hz 100 Hz 100 Hz 90 Hz 80 Hz 85 Hz 85 Hz 85 Hz 85 Hz 100 Hz 100 Hz 85 Hz 100 Hz 100 Hz 90 Hz 100 Hz 90 Hz 100 Hz 80 Hz 100 Hz 80 Hz 100 Hz 80 Hz 100 Hz 100 Hz VGA, MCGA SVGA XGA MAC SUN HP IBM RS6000 Silicon Graphics DEC NCR 34 USER GUIDE LCD PROJECTOR 14 CONNECTORS The pinouts of all external connectors are described. [. . . ]