User manual ASK PROXIMA DP9200

[. . . ] If the problem still persists, contact the sales dealer where you purchased the projector or the service center. SAFETY PRECAUTIONS WARNING : TO REDUCE THE RISK OF FIRE OR ELECTRIC SHOCK, DO NOT EXPOSE THIS APPLIANCE TO RAIN OR MOISTURE. Be especially careful that children do not stare directly into the beam. q Take appropriate space on the top, sides and rear of the projector cabinet for allowing air circulation and cooling the projector. If the projector is to be built into a compartment or similarly enclosed, the minimum distances must be maintained. [. . . ] Press the POINT LEFT/RIGHT buttons to select Computer and press the SELECT button. Move the arrow to the mode either Computer 1 or Computer 2, and then press the SELECT button. CURRENT MODE DISPLAY When selecting the Computer Mode, the Current Mode display appears to show the information of the computer being selected. Providing the information of the computer detected by the projector. SELECTING COMPUTER SYSTEM AUTOMATIC MULTI-SCAN SYSTEM This projector automatically tunes to most different types of computers based on VGA, SVGA, XGA or SXGA (refer to "COMPATIBLE COMPUTER SPECIFICATION" on page 25). When selecting Computer, this projector automatically tunes to the incoming signal and projects the proper image without any special settings. (Setting of the Computer System may be required when connecting some computers. ) Note : The projector may display one of the following messages. SYSTEM BOX Display the SYSTEM being selected. Go to PC adj. The projector cannot discriminate or detect the input signal from the computer. (Refer to page 26. ) No signal There is no signal input from the computer. Make sure the connection of the computer and the projector is set correctly. (Refer to TROUBLESHOOTING on page 42. ) The system being selected. SELECT COMPUTER SYSTEM MANUALLY To set the Computer system manually, select the mode on the ON-SCREEN MENU. The systems on this dialog box can be selected. When this mark is displayed as black, more computer system modes will be available. Move the arrow to this mark and then press the SELECT button, and the other modes will be displayed. 1 2 Press the MENU button and the ON-SCREEN MENU will appear. Press the POINT LEFT/RIGHT buttons to select SYSTEM and press the SELECT button. Press the POINT LEFT/RIGHT buttons to select IMAGE and press the SELECT button. Move the arrow to the function that you want to select and then press SELECT button. Standard Normal picture level preset on this projector. Custom Picture level adjusted manually in the custom setting dialog box. When selecting "w, " the custom setting dialog box will appear. Move the arrow to the item that you want to change by pressing the POINT UP/DOWN button, and adjust each value by pressing the SELECT button to match with the image. Fine sync Adjust the picture as necessary to eliminate flicker from the display. (From 0 to 127. ) Total dots The number of the total dots in one horizontal period. White balance (Red / Green / Blue) Move the arrow to the color that you want to adjust. (From 0 to 63. ) Contrast Point to w to decrease contrast, and select v to increase contrast. (From 0 to 63. ) Brightness Point to w to adjust the image darker, and select v to adjust brighter. (From 0 to 63. ) Sharpness Point to w to soften the image, and select v to sharpen the image. [. . . ] q Make sure you are not too far from the projector when using the Remote Control Unit. q Make sure the code of the Remote Control is set to conform to the projector. (See "SETTING" section on page 36, 37. ) q Check the cable connection between the projector and the computer. q Turn the projector on before you turn on the computer. Wireless Mouse function does not work. WARNING : High voltages are used to operate this projector. [. . . ]