User manual ASK PROXIMA DP6810

[. . . ] Before you do, we suggest that you spend a little time reading this guide to familiarize yourself with the operating procedures, so that you will receive maximum satisfaction from the many features included in your new projector. This user's guide will acquaint you with your projector's features. Through the years, we have found that many service requests were not caused by problems with our projectors. They were caused by problems that could have been prevented, if the owner had followed the instructions in the guide. [. . . ] The setting changed remains effective until the MAIN ON/OFF switch is turned off. 4. USA VIDEO SOURCE DISPLAY COMPONENT VIDEO SYSTEM SELECT When you select the "Y, Pb, Pr" by video source select. You must select the component video system (1080i, 1035i, 720p, 575p, 480p). Press the POINT LEFT/RIGHT BUTTON(s) to select SYSTEM and press the SELECT BUTTON. To change the current SYSTEM, press the POINT UP/DOWN BUTTON(s) to move the arrow to a desirable system and then press the SELECT BUTTON. MAIN MENU DISPLAY COMPONENT VIDEO SYSTEM DISPLAY 33 VIDEO MODE PICTURE IMAGE ADJUSTMENT Picture adjustments have been preset at the factory. Press the POINT LEFT/RIGHT BUTTON(s) to select IMAGE and press the SELECT BUTTON. In this dialog box, you can adjust the settings by increasing or decreasing the levels shown as numbers. The items and the range of the levels that you can adjust are summarized in the table below. Move the arrow to an item that you want to adjust by pressing the POINT UP/DOWN BUTTON(s). To increase the level, point the arrow to v and then press the SELECT BUTTON. MAIN MENU DISPLAY USA SCREEN ADJUST DISPLAY 35 COMPUTER MODE COMPUTER SYSTEM SELECT This projector is adjustable to different types of computer display signals based on VGA, SVGA, XGA or SXGA (See "COMPATIBLE COMPUTER SPECIFICATIONS" on the next page). If you set MODE SELECT to "COMPUTER", the projector will automatically process the incoming signal and projects the proper image without any special setting. Although this will work in most cases, you may be required to manually set the projector for some computer signals. If the computer image is not reproduced properly, try the following procedure and switch to the computer display mode that you want to use. Connect the COMPUTER to the PROJECTOR and turn the projector on first. This shows the current display mode initially detected by the projector in the system window. If the projector cannot discriminate or detect the input signal from the computer, the "Go PC adj. " display appears. If no input signal from the computer, the "No signal" display appears. Press the MENU BUTTON and the MAIN MENU DISPLAY dialog box will appear. Press the POINT LEFT/RIGHT BUTTON(s) to select SYSTEM and press the SELECT BUTTON. If you want to change the current display mode, move the arrow by pressing the POINT UP/DOWN BUTTON(s) to select one of the modes. [. . . ] NOTE: Moving the projector from a cool temperature location to a warm temperature location may result in moisture condensation on the lens. In such an event, leave the projector OFF and wait until condensation disappears. 51 APPENDIX Problem: Picture is L/R Reversed. Picture is T/B inverted. Try these Solutions: Check Ceiling/Rear feature. Press the MUTE button. Some displays are not seen during the operation. USA No sound. Remote control unit does not work. q Check the batteries. [. . . ]