User manual ASK PROXIMA C130

[. . . ] >>>>>>> User's Guide Declaration of Conformity Manufacturer: InFocus Corporation, 27700B SW Parkway Ave. Wilsonville, Oregon 97070 USA European Office: Strawinskylaan 585, 1077 XX Amsterdam, The Netherlands We declare under our sole responsibility that this projector conform to the following directives and norms: EMC Directive 89/336/EEC, Amended by 93/68/EEC EMC: EN 55022 EN 55024 EN 61000-3-2 EN 61000-3-3 Low Voltage Directive 73/23/EEC, Amended by 93/68/EEC Safety: EN 60950: 2000 March, 2005 FCC Warning Note: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. [. . . ] The remote also has Volume and Mute buttons to control the sound, and Video and Computer buttons to switch between sources. Use the Blank button to display a blank screen instead of the current slide (you can choose which color is displayed, see page 39); use the Effect button to invoke a user-definable action, such as freeze, or change your aspect ratio for viewing DVDs (see page 39 to learn to program this button). Previous and Next buttons allow you to navigate through your PowerPoint presentation while in Slide Show mode. Connect the USB connector on the provided computer cable to your computer to use these buttons. When you do this for the first time, the Add New Hardware wizard may appear. See page 15 for details on loading the correct USB drivers. previous button next button navigation buttons Troubleshooting the remote · · Make sure the batteries are installed in the proper orientation and are not dead. Make sure you're pointing the remote at the projector or the screen, not the computer, and are within the remote range of 15 feet (4. 5m). If you are trying to advance PowerPoint slides, make sure the USB cable is connected. If using a USB cable, make sure the correct drivers are installed. · 29 Using the audio Using the projector's speakers To use the projector's speaker, connect your source to the Audio In connectors (L and/or R) on the projector's composite connectors. To adjust the volume, press the Volume buttons on the keypad or remote. Troubleshooting Audio If you aren't hearing the audio, check the following: · · · · · · · Make sure the audio cable is connected. Make sure that you are connected to an "audio out" connector on the source as opposed to a "line-in" or "microphone" connector. If playing a video, make sure the playback has not been paused. external speakers with own power source audio out speaker cable adjust volume connect audio cable Connecting external speakers The projector can be attached to external amplified speakers by connecting a 3. 5mm stereo audio cable from the Audio Out connector on the projector to the amplified speakers. Alternatively, you can bypass the projector's audio system and connect the audio directly from your source to a stereo or home theater system. 30 Using the keypad buttons Most buttons are described in detail in other sections, but here is an overview of their functions: Menu­opens the on-screen menus (page 34). Up/Down arrows­navigates to and adjusts settings in the menus (page 34). Video and Computer­changes the active source. menu navigation buttons 31 Optimizing computer images After your computer is connected properly and the computer's image is on the screen, you can optimize the image using the onscreen menus. · · · · · Adjust the Keystone, Contrast, or Brightness in the Picture menu (page 35). Adjust the Phase, Tracking, or Horizontal or Vertical position in the Advanced menu (page 37). Once you have optimized the image for a particular source, you can save the settings using Presets. This allows you to quickly recall these settings later (page 36). Presentation features Several features are provided to make giving presentations easier. · The Effect button on the remote allows you to assign various features to the button. The default effect is About, which displays information about the projector and current source. [. . . ] The Lamp Product Limited Warranty excludes expected lamp degradation and InFocus will not be liable for normal decrease in lamp output over time or as lamp is consumed under the Limited Warranty. Remanufactured Products and Software Products are exempt from the foregoing Limited Warranty. Please refer to the appropriate Remanufactured Product Limited Warranty or Software Product Limited Warranty for applicable Warranty information. DISCLAIMER OF UNSTATED WARRANTIES THE WARRANTY PRINTED ABOVE IS THE ONLY WARRANTY APPLICABLE TO THIS PRODUCT. [. . . ]