User manual ARIETE 0953

[. . . ] Do not use the appliance if the power cord or plug are damaged or if the appliance itself is faulty; all repairs, including substitution of power cord, must be carried out exclusively by an Ariete assistance centre or by authorized Ariete technicians in order to avoid all risks. In case of using extension leads, these must be suitable for the appliance power To avoid danger to the operator and for the safety of the environment in which the appliance is being used. Never allow the cord to dangle in places where it may be grabbed by a child. Do not threaten the safety of the appliance by using parts that are not original or which have not been approved by the manufacturer. [. . . ] The microwaves are electromagnetic radiations that are also present in nature in the form of light waves (e. Sunlight) and that, inside the oven, go through food from any directions and warm up the molecules of water, fat, and sugar. The heat is produced very quickly only in food, while the container warms up only indirectly for heat transfer from hot food. This prevents the food from adhering to the container, therefore it is possible to use very little fat or to avoid its use during the cooking process. The microwave cooking is deemed to be very healthy and dietetic since it is low fat. Furthermore, in comparison with the traditional systems, as cooking is at a lower temperature, the food dehydrates less, does not lose its nutrients and preserves its flavour more. HOW TO OPERATE CLOCK SETTING When the microwave oven is plugged in, the display (E) will show "0:00" and a "beep" will be emitted. - Press the button (H) "Clock / Preset" once; the hour indicator will start blinking. - Rotate the dial (M) to increase or the decrease the values of hours (from 0 to 23). - Press the button (H) "Clock / Preset", the minute indicator will start blinking. - Rotate the dial (M) to increase or decrease the values of minutes (from 0 to 59). - Press the button (H) "Clock / Preset" to confirm setting; the sign ":" will flash and the display (E) will show the time set. WARNING: If the clock is not set, it will not work when the appliance is plugged in. The clock setting does not remain stored if the appliance is unplugged. If no operations are carried out for 1 minute during the clock setting process, the appliance will go back to the previous settings automatically. "MICROWAVE" COOKING - Press the button (F) "Microwave", the display (E) will show the power "P100", which will flash. - Press the button (F) "Microwave" several times or rotate the dial (M) for increasing or decreasing The values to select the required power, which will be shown on the display (E) ("P100" corresponds to 100%, "P80" to 80%, "P50" to 50%, "P30" to 30%, or "P10" to 10%). - Rotate the dial (M) to increase or decrease the values of the cooking time (from 0:05 to 95:00 min. - The microwave oven will start cooking, the inner light will go on and the display will show the time left. - To stop cooking, open the door or press the "Stop / Clear" button (I): the program set will be paused and the remaining time will stop on the display. - To restart cooking, close the door and press the button (L) "Start / +30 sec. Example: If it is required to use 80% of the oven power to cook for 20 minutes, proceed as described below: 1) Press the button (F) "Microwave" once, the display will show "P100" flashing. [. . . ] - Rotate the dial (M) to increase or decrease the values of minutes (from 0 to 59). - The oven will emit two "beeps" when reaching the pre-set start time, then cooking will start automatically. Note: The clock must be set from the beginning, otherwise the pre-set function does not start. INFORMATION SHOWN WHILE COOKING - During microwave cooking, pressing the button (F) "Microwave", the display will show the current power for 3 seconds. [. . . ]