User manual ARCAM P35

[. . . ] The case should normally only require a wipe with a soft, damp, lintfree cloth. We do not advise the use of furniture cleaning sprays or polishes as they can cause indelible white marks if the unit is subsequently wiped with a damp cloth. Power sources Only connect the appliance to a power supply of the type described in the operating instructions or as marked on the appliance. Power-cord protection Power supply cords should be routed so that they are not likely to be walked on or pinched by items placed upon or against them, paying particular attention to cords and plugs, and the point where they exit from the appliance. [. . . ] If this is set to `Disabled', the amplifier comes on at the last used volume. This specifies the scope of changes for `Bass' and `Treble' tone settings. the default setting is `Global' which affects all inputs equally. `Per source' allows you to set tone controls for individual inputs: once set, the amplifier remembers tone settings for each input. processor Mode ­ This mode enables you to adjust the gain of the amplifier. The amplifier can then be used to drive the front left and right speakers in a surround sound system when fed from a separate processor. The volume of the entire system can then be controlled using the processor. set the gain to match the amplifiers that drive your other loudspeakers. Welcome message ­ You can change the power on `Welcome message' from `Arcam Amp' to display your name, postcode, etc. When customising the message, use the UP and DOWN buttons to select the cursor position and the Control knob to change the letter. Phono/Aux Text ­ The C30 is fitted with a phono module, so when the phono input is selected as the source, `PHONO' is displayed. Should you wish to remove the phono board, then the AUX connections can be used as a line input. In this case, change the text displayed to `AUX', using this menu option. Restore Settings ­ this restores all amplifier settings, including input trims and the welcome message, to their factory defaults. The default display mode is VOLUME, where the Control knob is used to adjust the sound level. Press SELECT once to enter edit mode, then repeatedly to cycle through the other sound settings: BALANCE, BASS and TREBLE. When a setting is selected (shown on the display), it can be adjusted by using the control knob. Press ENTER to store the change you have made and return to default (volume) mode, or press SELECT again to move to the next setting. It is possible to customise (change to your preference) many of the features of the C30. Press SELECT repeatedly until the display shows `CUSTOMISE->'; Rotate the Control knob to choose which setting you wish to alter; Press SELECT to adjust the chosen setting with the Control knob; Press ENTER to confirm the adjustment, or press SELECT to confirm the adjustment and move on to the next item. CR-389 Remote Control The CR-389 remote control gives access to all functions available on the front panel of the C30. Note that the FM/DAB lights indicate into which mode you are switching the remote control. [. . . ] Loudspeaker cables ­ two pairs of cables per loudspeaker or a suitably terminated cable set (a loom, probably prepared by your dealer and capable of being used for bi-amping in one length). WARNING:This step is essential or damage to your amplifier may result which is not covered under warranty. Connect the cables as shown in the diagram below, ensuring correct polarity at all times. Use the interconnect cables to connect the PRE OUT sockets of the C30 to the corresponding AUDIO IN sockets of the power amplifier. [. . . ]